drsportster
Member
My wife has an od clock that seems wound way too tight . If I get [or make ] an unwinding tool will that fix it ?
You can't wind one too tight, they are designed to wind the springs by hand until they stop. The only way to wind one too tight is to turn the key until it stops and then put a wrench on the key. That would probably break the spring.My wife has an od clock that seems wound way too tight . If I get [or make ] an unwinding tool will that fix it ?
I think it is wound tight because the keys can't be turned further
Can you remove the case and see if the spring is completely wound. It's normal to not be able to turn the key any further if the spring is wound tight but if the spring is broken sometimes they get into a bind and the key won't turn. It's not really a diy thing to replace the spring. The mechanism would have to come apart and have a new spring installed. Just getting the broken spring out is bad enough, it will want to unwind and it has sharp edges.I think it is wound tight because the keys can't be turned further
I think it is wound tight because the keys can't be turned further
can you work the balance wheel? flip it with your finger or a q-tip. try to make it tick.I think it is wound tight because the keys can't be turned further
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy