Wifes old clock

My wife has an od clock that seems wound way too tight . If I get [or make ] an unwinding tool will that fix it ?
You can't wind one too tight, they are designed to wind the springs by hand until they stop. The only way to wind one too tight is to turn the key until it stops and then put a wrench on the key. That would probably break the spring.

What is it doing that you think the spring is wound too tight?
 
I have a German wall clock from the 70s that quit working and I thought it was wound too tight. Went to a clock place with it and just needed disassembly and a good lube job. He got frustrated putting it back together and went out to smoke. I finished that part waiting on him, so he knocked some off the price. He did a lot of little adjustments to the chimes I would have had no clue how to do, so it was worth whatever I paid considering it was the first time it was touched over the years.
 
I agree with B.White. It needs a cleaning and lube job. II work on clocks and that's what I get most of the time. The factory lube has a tendency to harden up after many years. Could also be worn so bad in the pivot holes in the plates that the gears are not meshing properly. 👨‍🌾
 
I think it is wound tight because the keys can't be turned further
Can you remove the case and see if the spring is completely wound. It's normal to not be able to turn the key any further if the spring is wound tight but if the spring is broken sometimes they get into a bind and the key won't turn. It's not really a diy thing to replace the spring. The mechanism would have to come apart and have a new spring installed. Just getting the broken spring out is bad enough, it will want to unwind and it has sharp edges.
 
Dad collected old wall clocks. I remember when he began (1956), one clock mechanism was dirty with dried oil on everything metal. He sprayed the works with WD40, since it's advertised as a cleaner and lubricant. It ran fine until the WD40 dried to its waxy film, then everything stopped working. It cost him a lot of money for a clock maker to completely disassemble the works, clean all the film off, then reassemble the works. That was a very expensive lesson he learned.
Nearly all of his old wall clocks, he bought in Frankenmuth MI. All were imported from Germany.
Later he bought a new Howard Miller grandfather clock, AND a Howard Miller oiler containing their blend of clock oil.
 
I have this old school clock I salvaged from a job I did many years ago. It has been running pretty well until recently.
It appears there is a delicate balance between the escape adjustment at the top of the escape gear and the weight in the pendulum.
Hope it is not just pain wore out.
 

Attachments

  • wall clock1.jpg
    wall clock1.jpg
    1.6 MB · Views: 0
  • clock1.jpg
    clock1.jpg
    2 MB · Views: 0
  • clock2.jpg
    clock2.jpg
    2.2 MB · Views: 0
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top