CG1981

New User
I have recently aquired a farmall 350D row/crop and I want to restore it and get it running, I noticed that it has been upgraded to a 12v alternator and I am wondering if anyone has a schematic for this. It has a 4 pin rectifier/regulator mounted to the frame but all the wires were off when I got it. Would it just be easier l/better to go back to a generator?
 
I believe they were 12 volt from new. Our MD was 12 volt. I would just put the alternator on with out all the nonsense and have a 3 wire one charge good. As for the wiring. There is so little wiring to those old tractors you can make the harness cheaper.
 
I suspect the 4 pin rectifier/regulator is left over from the generator days. It is not needed as the alternator should have its own regulator built in. Get the engine running first and see if you have an ammeter reading to show charge. If it shows charge, there should be no additional wiring needed. Definitely keep the alternator if you find it to be charging.
 

The alternator has 2 wires coming out of it and one post, the ends of the 2 wires have terminals that would connect to the rectifier as well as one coming from behind the gauges.
 
Assuming you tractor has a Delco alternator now, quickest, least expensive and most reliable is to replace it with a Delco 12SI internally-regulated alternator.

It will be a direct mechanical replacement for the existing alternator. And wiring is simplified over the one you have now (no external regulator required)

The 12SI was used on nearly all GM cars from the late 70's thru mid-80's. Ask for an alternator for a 1980 Chevy pickup without air conditioning and you'll be set.
 
Hello CG welcome to YT! Here in the first link is
essentially what your wiring will need to look like if you
have a Delco 10si alternator less the ignition circuit. I
assume the 350D had the same ignition setup as the
gas we had that you turn on a key or switch and then a
push button to start. So in that case the diagram
shows the starter button powered all the time which it
is not. Also the diode shown can also be replaced with
a incandescent dash warning bulb wired in the circuit
like a resistor. On second thought you may not even
need a diode or bulb if you cut fuel buy a lever to the
pump. The diode/bulb is only to enable a spark ignition
engine to shut off and and not continue to run off the
power from the alternator excite circuit. The 2nd link
shows an example of a 10si alternator for visual
comparison. The 2 small wires plug in the side. If they
plug in the back you actually do have a 60s and early
70s Delco that requires an external regulator. The
regulator for those had a four or five plug to plug on
flat tabs on the regulator. The original generator
regulator would have screws to connect the wires. Be
careful on here using the word ..restore.. when you are
not keeping a machine 100 percent original, your
tractor would have originally had a generator. The
..correct police.. are mellowing out lately.
Wiring diagram

Example alternator
 
Best to confirm which alternator you have, before continuing. Two plug-in spades on the alternator could be a three wire 10 or 12 SI type [u:53de57a3fa]or[/u:53de57a3fa] it could be a 10DN given you posted "It has a 4-pin rectifier/regulator mounted to the frame, but all the wires were off when I got it." Yes, that may well be from a generator system, but it could be from an early conversion to a 10DN externally regulated alternator. A generator regulator will have screws in the tabs where the wires connect. The regulator for a 10DN will be spade tabs for a plug-in connector.

mvphoto95601.jpg


mvphoto95602.jpg


mvphoto95606.jpg


mvphoto95604.jpg


mvphoto95605.jpg
 
See what I mean, still a few left. ;>) If you view on Classic you will see what I am referring to. Nothing wrong with it, they just like to keep the term pure. It is a mouthful, but you are repairing and modifying to your liking.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top