ZA Clutch

[wnymolines]

I"m getting ready to swap the pulling motor into our ZAS and I want to update the clutch. Can you folks tell me what parts I will likely need to replace so I can have them here at the start of the job? Thanks in advance for allyour help.

 

[MM ZAck]

You will definitely want to take your friction disk out and have it re-lined. Also since you're in there, you should replace the pilot bushing in the flywheel. These are the main two things. You could have your flywheel surfaced, but it's generally not necessary unless there are grooves in it from rivets wearing on it.

Check the linkage for wear, but they are generally ok. The ZA clutch is adjustable, so you will be able to set how much force it takes to snap it over center.

Zack

 

[Anonymous-0]

You should also replace the transmission seal on the clutch shaft.

 

[Anonymous-0]

is the clutch in my ZB adjustable ??