(800) 853-2651
SHOP NOW

Recent content by 730d se

Yesterday's Tractor Forums
  1. 7

    730 Diesel w/pony ignition switch

    I need a new ignition switch for my 730 D w/pony. Who sells the best one?
  2. 7

    what would you consider low hours for a backhoe?

    Another obvious point to remember with "used" equipment is this. They are selling for some reason. Many times it can be because their mechanic has discovered something that is about to cost a bunch of money. They have depreciated it off the books in most cases, so it makes more biz sense to buy...
  3. 7

    into the PTO I go!

    I found an NOS PTO shaft so with the new disk, this one is almost new again.
  4. 7

    into the PTO I go!

    I decided to replace the piston O-ring and wiper while I had it all open. My O-ring was trash, allowing the 3 point to leak down or "hiccup" when a load was on it. All other test are good.
  5. 7

    into the PTO I go!

    Closer pic of the pump. Be sure to have the JD service manual as the pump is unique in how it is removed and replaced. New oil seal is installed.
  6. 7

    into the PTO I go!

    I am finishing up a 730 Diesel Powertrol/Live PTO rebuild so I will share a pic. The Powertrol casting is extremely heavy so be careful and have some help and a good means of lifting. My guess is 500 LBS. The pump is at the bottom with the splined shaft. The seal is on that shaft. It is best to...
  7. 7

    Powertrol Housing oil seal

    Bob, You are spot on, thanks for the fast reply. I looked at it and it just did not seem to draw a direct to the same hole. But now that I looked again, that is the one that I need. Thanks again!
  8. 7

    JD 730D Powertrol piston

    New o-ring and wiper, should fix the drifting down issue of the hitch.
  9. 7

    Powertrol Housing oil seal

    What is the part number for the oil seal where the shaft goes in that operates the lift? It goes in on the right rear of the housing. I cannot find a part number in the parts book on any of the pages showing the Powertrol Housing.
  10. 7

    60 PTO clutch oil

    I would not use anything but hydraulic oil that is to HyGuard standards. I would not use trasnny fluid, this is a wet clutch sytem, not an automatic transmission.
  11. 7

    MI JD tractor

    Bryce, I have a few M-20 mower parts. You can let me know what you need. One thing I have is very hard to find, it is the belt shield for the PTO.
  12. 7

    Cody adgent Tenn

    When a fellow is willing to type on a public web site that he would return my money, I would take him up on it and return the product. Very few companies will refund shipping charges, it is just the way it is.
  13. 7

    outrageious prices

    Car makers figured out some years ago that they have at least four ways to rip us off. 1. Selling the vehicle. 2. Over priced options and add ons. 3. Financing the vehicle. 4. Designed parts failure. Once you buy their "razor", you have little choice in some cases but to buy their "blades" at...
  14. 7

    Placement of 730 D decals

    If you do not care that the decals are old and could be defective, I would not be too concerned about where they go. Best place to look is in the JD service or parts manuals. They have black and white shots of the actual models. One thing to note, the decal placement back then was not a science...
  15. P

    CA Front Wheel Wobble

    I have a narrow front CA that leaks fluid from the steering pedistal and the front wheels wobble some. I'm thinking bearings and seals. Anything else? Good source for parts? Thanks.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top