(800) 853-2651
SHOP NOW

Recent content by 8nfeller

Yesterday's Tractor Forums
  1. F

    Hyd fluid level on 861

    Plowing snow today and had to run an erand. Backed the tractor to the edge of the snow pile and left tractor with the blade on top of the pile. When I got back couple hours later the 3pt wouldn"t lift. when I renoved the fill cover it looked low I thought, can anyone tell me in general how much...
  2. 8

    8N 12 volt battery

    On mine you just have to give it a little tilt to get the battery terminals past the hood
  3. 8

    8n drums.

    no, they are not needed
  4. 8

    3 point not lifting heavy objects

    you have a leak somewhere in the system. looking in the instection plate you should be able to see where the leak is.
  5. 8

    Distributor Problem

    on my front mount it will rub if the gasket under the cap is missing. Doug
  6. 8

    jobs

    I use mine for: post hole digging tilling snow plowing mowing 5 ac.
  7. 8

    8n Serial # question

    yours will be 48,49 or 50 8n I had same issue. I used paint remover and a tooth brush to clean the area up. also a light head above or below marking help give definition to numbers
  8. 8

    parts catalog

    shoot me an email and I can send you a link to what you are looking for doug
  9. 8

    My first tire chains

    I just bought my fist set a couple of weeks ago. They should make quite a difference this cleaning the drive this winter. My tires are not loaded. I installed mine by jacking one side up at a time and letting the air out of the tire. Install the chains and then inflate the tires again. I was...
  10. 8

    another suprise

    When I bought my 52 8n the air filter was packed full of grass clipings. I was supprised that could get enough air to run Doug
  11. 8

    Snow removal with rear blade

    I do both with my rear blade . Doug
  12. 8

    8N 12V Altenater

    NAPA carrys them Alternator - Remfd, Delco 10SI Product Line: NAPA Power Premium Plus $44.12 Each is the one I use
  13. 8

    52 8N coil mount

    "Does the ignition coil mount and spark plug wire loom clamp mount using same bolt to head? " YES "does plug clamp go on top of coil mount?" on mine the coil bracket is on top on the loom clamp Doug
  14. 8

    2N runs for around 30 min and stops

    had similar issue cause by bad coil. run it until it dies and check to see if you have spark
  15. 8

    RUST on my N Fenders

    I use jb weld to fill holes in my fenders. Holds up very well Doug
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top