(800) 853-2651
SHOP NOW

Recent content by ANDY E

Yesterday's Tractor Forums
  1. A

    ? farmall pullers

    anyone ever use an 450 lp head with the original m&w 5.75 stroker crank.
  2. A

    JD B CARB

    clean the jets again re-install carb works great now. thank for the information
  3. A

    JD B CARB

    I have an 52 b. rebuilt the carb. can get it to idle, but when I govern opens it wants to die unless I pull the choke out. have run the load screw out and in makes no difference. any ideas???
  4. A

    PULLING HITCHES

    where can I get pics of pulling hitches for a Farmall m?
  5. A

    compression check

    what is the proper procedure to compression check each cylinder?
  6. A

    450 w/ 4.25 pistons

    pilled the head off my 450 today, pushed the pistons out of the block, i thought they were M & W, until i seen them they were stamped with AP-79, who manufatured these pistons? heres some pictures.
  7. A

    puller project #1

    that wide front is very heavy. no belly pump. pto removed. single front wheel is light. pressed steel wheels on rear
  8. A

    puller project #2

    when i put the tractor together the block was bare. the 1st pull was close, all i had was a can of john deere spay paint so i painted it green. went to the 1st pull and it got named "THE GREEN MOTORED M" so i just left it green.
  9. A

    puller project #1

    will weigh in arount 4200, was a good puller won 4500 class in the state in 1992.
  10. A

    puller project #2

    did you see the 18.4 x 38 bfg in the back round. they were duals for the 4020 in early 1970's worked only one season. still new.
  11. A

    puller project #2

    those tires still have the little rubber teets on them and they are hard as a rock.
  12. A

    puller project #2

    this old girl is another 39 sn 5998, she has won me more money and trophies then the other tractors have combined. my, wife, daughter, family and dog are the only things I cherish more than her. I have not kept her up as well as should have over the many years. when I first put her together i...
  13. A

    puller project #2

    this old girl hasn't been on the track since she won the state @5500 and 2nd in the state @6500. brought her home from that pull and noticed she had water in the oil from a crack in the cylinder wall that I repaired in 1989 when I put her together for pulling. Need to pull engine. find new m...
  14. A

    puller project #1

    This 39 m hasn't been on the track, or started since 1996. Need to pull it to the shop, change oil. tune up, dyno check, matbe some paint. Load on the trailor and go pull this summer.
  15. A

    Decals for 39 M

    39 HAD DIFFERNET DECALS THAN LATER MODEL M. THINK THEY SAID MCCORMICK DEERING. DON'T REMEMBER FOR SURE, PRETTY SURE THEY WHERE DIFFERENT
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top