(800) 853-2651
SHOP NOW

Recent content by Axell

Yesterday's Tractor Forums
  1. A

    Rear bucket width

    Mostly to move manure.
  2. A

    Rear bucket width

    Hi I have a mf35 and I found a used 80 inch rear bucket. Is that too wide for it. Should I look for something much narrower?
  3. A

    Engine plug repair

    It was drained from the engine drain tap and perhaps also from the radiator and was left empty untill now. So how it woukd get damage from freezing I dont know. The little water left should have room to expand
  4. A

    Engine plug repair

    Yes, I think it is the timing cover. Looks like a job too big for me.
  5. A

    Engine plug repair

    Hi My ih624 has been sitting for a couple of years. Started it and it ran for a few seconds. White smoke. Cant start it again. Found out it had no coolant. I remember i drained it. Put new water in and it is leaking heavely from radiator bottom and from an engine plug behjnd the water pump. The...
  6. A

    Pto shifter positions

    On my ih624 the pto shifter has three positions: pto independant, neutral and pto shifter lever, neutral. The two latter seems to do the same. The pto shaft ka. Be turned freely by hand
  7. A

    Run without exhaust?

    Only have a stick Welder and little experience. Welding cast Iron isnt easy, they say. For now i have attached the elbow With wire and some exhaust paste.
  8. A

    Run without exhaust?

    I Hit something lower than the mufler on my super major and it broke where it is mounted to the manifold. Will the engine run fine without the mufler?
  9. A

    Whining gears?

    I actually put 80w90 in it as I have lots of it but got cold feet because what if the seals between engine, gear and rear are leaking. Mixed oils isnt good is it? I have some 20w50 I plan on using for the engine. But perhaps I should buy some more for the gearbox. It is a tractor/oil spreader...
  10. A

    Whining gears?

    Hi! Was out driving my super major for the first time doing some work in the field. When in 4/2 there is a whining noise. A little less in 3/1 and none in 6/5 and rear. Cant quite tell where it is comming from but the foot rest on the left is vibrating. Feels like touching an oscilating...
  11. A

    Fuel tap turns

    Hi! How many turns should the fuel tap be turned to be fully opened? I have seen some turn a few turns and some up to 20 turns. Is this supposed to be turned more than half a turn? Like a ball valve.
  12. A

    35 or 35x? Genuine?

    Thanks for the good reply. Doesnt look too good anymore. Perhaps because is isnt air tight. When weather is humid a lot of condensattion builds up on the inside of the glass. The hour meter is stuck. Unfortunately.
  13. A

    35 or 35x? Genuine?

    Mine looks like this
  14. A

    35 or 35x? Genuine?

    Yes the injectors are vertical.
  15. A

    35 or 35x? Genuine?

    Yes, added it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top