(800) 853-2651
SHOP NOW

Recent content by burnsg2003

Yesterday's Tractor Forums
  1. B

    Vermeer 605g round baler

    Any suggestions where I could find a lower roller and triple sprocket for a vermeer 605g round baler. Thanks in advance for you help.
  2. B

    New Holland 462 disc mower

    Thanks for all your help I will try a washer.and see what happens
  3. B

    New Holland 462 disc mower

    I really was hoping it was loose and would tighten down
  4. B

    New Holland 462 disc mower

    I turned it maybe quarter of a turn
  5. B

    New Holland 462 disc mower

    I tried tightening the nut. Thanks for the reply
  6. B

    New Holland 462 disc mower

    I have a 462 new Holland disc cutter the dis cutter closest to the tractor will wobble about a 1/2 inches when I make it move. When rotating it seems to be ok the only reason I discovered it moved was I put all new blades on all disc it is the only one with the wobble.has anyone else had this...
  7. B

    JD 2640 tach cable replacement

    Thank you
  8. B

    JD 2640 tach cable replacement

    Where does the cable on a 2640 connect to the engine. It looks like it connects under the battery case. If so how is the battery box removed since it looks like it is connected to the dash. Any comments or information is appreciated. Have googled looking for info but found very little information.
  9. B

    Baler parts for Vermeer 605g baler

    Is there any places that scrap out balers that might have used parts for a Vermeer 605g baler. I need the roller behind the intake roller and the gears that go on that shaft. Thanks
  10. B

    JD 4010 hydraulic leak rear

    Right behind the big pin that runs through the three point hitch it is leaking hydraulic oil. I see no reason why this should be leaking unless there is a seal. Any input or suggestions appreciated.
  11. B

    Vermeer 605g baler is it timed

    I have to disconnect the drive chains on my 605g baler by removing the three gear assembly behind the intake roller. Are these chains an gears and chains timed. Have tried reading about this but found no information .any comments or advice appreciated
  12. B

    Vermeer 605g baler

    I have a 605g baler that one of the lower rollers the bearing is out. It is the roller with like three fears mounted on it. I presume the chains have to be taken off and gears removed. The outer gear has been welded along with the key if I cut it off can I get a new one. Attached a photo any...
  13. B

    John Deere 4010 starting issues

    I have a John Deere 4010 with a 4020 diesel engine that was converted to a 12 volt system. Had issues with it starting period bot figured out I had some grounding issues,a starter problem all of which were fixed. Have went about a year with no starting problems. Just this past week it starts but...
  14. B

    IH 370 disk

    I need to replace the front blades on my 370 disk. They are concave blades but somewhere ready they should be flat centers. Also where is the best source to obtain the blades. Any comments appreciated
  15. B

    Vermeer 605G baler

    I have been looking for a big round baler but not found Any in the price range and year I wanted. Was talking to my neighbor and he has a Vermeer 605G baler he used last summer to bale 80 some bales of hay. It's older than I wanted but the belts are fairly new and it has a new upper roller. The...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top