(800) 853-2651
SHOP NOW

Recent content by Cal in TX

Yesterday's Tractor Forums
  1. C

    Mower Questions

    Thanks for the reply, Pete. I am talking about a bush hog type cutter, not a finish mower. My Jubilee is in excellent condition, full power from engine and hydraulics. Think it will handle a 6 foot cutter OK? The limiter chains limit the distance that the lift can drop toward the ground...
  2. C

    Mower Questions

    What is the correct size 3ph mower for a Jubilee - 5 foot or 6 foot? Also, will I need to use a limiter chain? Thanks! Cal in TX
  3. C

    What do you think of these mowers?

    Colin - We've had a JD Gyramor on our farm since 1972. We cannot wear it out. It gets at least 60 hours of heavy use every year and I swear the only thing we've replaced on it are the blades once and 1 U-joint bearing. Keep it greased and lubed and it will last forever. I never saw anything...
  4. C

    Horse Nettle

    Today was one of those days you dream about in East Texas - 70 degrees, light breeze, brilliant sunshine, not a cloud in the sky between El Paso and Texarkana. The air was so dry that the sky was almost navy blue. I got on my Jubilee at 8:30 this morning and except for gas and water breaks...
  5. C

    Help Cure my Absentmindedness!

    I have one of those, Colin. It is too tall and my hood door will not close when it is installed. I don't know if this is a problem just with my setup or not but it sure wouldn't fit on my NAA. My gas tank if within an eighth of an inch of the hood and it has a hump in the middle that...
  6. C

    OT But I Gotta Share - Don't Read if OT Upsets You

    Every time I mow my pasture I am joined by about 30 egrets who feast on the grasshoppers that I stir up and one big beautiful hawk that sits high in a walnut tree and watches for field mice and such. Last weekend after a few minutes of mowing I noticed that the hawk had joined me as usual. She...
  7. C

    Help Cure my Absentmindedness!

    Saturday morning - 6:45am. It's a beautiful East Texas morning, not too hot, just gorgeous. I do a full grease job on my NAA, put in 5 gallons of fresh gas and away we go to the back pasture to mow. With every round I am enjoying it more. The day is perfect, the tractor is purring like a...
  8. C

    Should I Run it Dry?

    This has probably been asked a thousand times before but I can't find it so here goes: When I finish with my NAA I always shut off the gas feed from the tank, however, should I let the tractor run until the gas is gone from the carb or should I shut the tractor off and leave the gas in the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top