-
C
NH273 supersweep vs. standard
When I bought my NH273 last year, I got a two for one deal. A working 273 with standard pick-up and another 273 for parts that has a super sweep. Here's my question . . . I need to replace teeth in the working 273, but would like to have the super sweep. Is it possible to change out the...- Circle-P
- Thread
- Replies: 1
- Forum: Implement Alley
-
C
NH273 haydogs
Just came in from the field; got my springs today from another NH dealer in a neighboring town. Wow is all I can say in the difference in my bales last year and my bales today with all of the haydogs working properly.- Circle-P
- Post #1
- Forum: Implement Alley
-
C
NH273 Haydogs
Yes, that's exactly what my haydogs looked like; not anymore though after 8+ hours of blood and sweat. I have never before encountered something so seized-up as the dogs were around the pins. I was incorrect about the pins, I did have enough new pins to replace them, cleaned my dogs real good...- Circle-P
- Post #1
- Forum: Restoration Processes
-
C
NH273 haydogs
I keep getting my post on the wrong forum - maybe one day I'll figure this out completely. The top 3 on my NH273 were froze in the up position. The bottom 2 were not froze-up completely, but we lubed them and they move more easily now. The dealer did not have all the parts in-stock. One new...- Circle-P
- Thread
- Replies: 3
- Forum: Implement Alley
-
C
NH273 Haydogs
The top 3 on my NH273 were froze in the up position. The bottom 2 were not froze-up completely, but we lubed them and they move more easily now. The dealer did not have all the parts in-stock. One new hay-dog, no springs, and one pin is all they had. The rest they will have to order; and I...- Circle-P
- Thread
- Replies: 4
- Forum: Restoration Processes
-
C
Cleaning Knotter Assembly - NH273
What is the correct way to clean the dirt and debris from the knotter assembly? Will using pressure (whether water or air) damage the working mechanisms? Thanks!- Circle-P
- Thread
- Replies: 2
- Forum: Implement Alley
-
C
cleaning knotter assemblies
What is the correct way to clean all the dirt and debris from the knotter assembly? I have NH 273.- Circle-P
- Thread
- Replies: 2
- Forum: Restoration Processes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy