(800) 853-2651
SHOP NOW

Recent content by dleefarms

Yesterday's Tractor Forums
  1. D

    755 John Deere Injection Pump

    I have a 755 Deere with injection pump issues. There is ample pressure going into the pump however after taking the injector lines loose there is no fuel squirting out of the top of the pump. The tractor has been sitting for a while. Could it be that the IP is just gummed up and can be...
  2. D

    755 Compact

    I have just recently acquired a 755 with a fuel issue. It appears that there is an issue with the wiring harness pigtail where the fuel shut off solenoid plugs in. In starting attempts it appears that the faulty wiring has the fuel flow shut off as the plunger in the solenoid will not stay...
  3. D

    1520 PTO Seal

    I'm in need of changing the PTO seal in my 1520. Per the shop manual I have removed the 3 bolts that hold the housing to the rear of the tractor. Anyone have any tricks to getting the housing/shaft to pull out? Thanks in advance.
  4. D

    Please help identify this 1960s Ford

    Trekker42 - the numbers you provided are not the ones that determine the model - these are casting numbers. The numbers needed are stamped (not raised) in the frame just above the starter on the flat surface. It appears this has been painted so there may be a large amount of scraping with a...
  5. D

    265 Massey Hydraulics

    I'm looking at obtaining a 265 for my mowing and baling. It doesn't have a remote setup. How is the best way to install a remote valve and hoses? Thanks.
  6. D

    856 "barfs" hydraulic fluid from behind the st

    It is the hand pump that allows for manual steering. You have to remove the steering wheel to access the pump and replace the seals. Be sure to have a shop manual handy.
  7. D

    3000 Spindle Issue

    Thanks everyone - you have confirmed what I thought. Just have to work at it.
  8. D

    3000 Spindle Issue

    The thrust bearing went bad and when I dropped the spindle out of the housing the bearing cup stuck in the housing. Anyone know a trick to getting this cup out of the housing?
  9. D

    1520 Deere

    Yes linkage connected and no line leaks. I did notice a few days ago leak down of the right (outside) pedal if I had to hold it a while. Was working ok when I started yesterday and 2 hours later nothing.
  10. D

    1520 Deere

    Yes the remote valves are correct. I have all hydraulic functions except brake pedal.
  11. D

    1520 Deere

    Quick question for the brain trust. Yesterday after raking hay I lost all brake pedal. Still have all other hydraulics but push down on the pedals and they go straight to the floorboard - no stopping. Any thoughts would be greatly appreciated.
  12. D

    3000 Spindle Play

    How much play should there be in the spindle, if any? I just noticed that the spindle will move up about an 1/8 of an inch with the front jacked up to fix a flat. Thanks in advance.
  13. D

    Ford 3000 power steering cylinder lines

    The first thing I would do is swap the lines on the cylinder ends. I have done this a few times and even if I do a diagram I still get the lines crossed.
  14. D

    766 Steering Issue

    Tractor Vet - I have the pump back in and ready for the steps for the adjustments you mentioned. thanks.
  15. D

    1959 IH B275 changed fuel filter air in lines. Trouble b

    Joe, woreout is right. Too bleed the air properly you have to start at the filters, then break the nut loose going into the injector pump from the filters. Once the air is out there move to the top of the injector pump and break each of the 3 injector lines nuts loose. Once air is out there...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top