-
D
3 wire altenator indicator light or diode? Ammeter guage?
Yes. It is LED, im sure. I cant find the correct correct replacement fixture so I think I'm going to just leave it as is being that its not causing any issues.- Dwd14329
- Post #18
- Forum: Ford 9N, 2N & 8N
-
D
3 wire altenator indicator light or diode? Ammeter guage?
Good idea 👍- Dwd14329
- Post #16
- Forum: Ford 9N, 2N & 8N
-
D
1947 Ford 2N governor upgrade.
2N owners or specifically 2N experienced DIY members. Most importantly, can i upgrade to a proof meter ready governor? My governor does not have a proof meter cable hook up. I cannot find a full assembly anywhere? Has anybody located one new or used? A full assembly- Governor, cable and gauge...- Dwd14329
- Thread
- Replies: 4
- Forum: Ford 9N, 2N & 8N
-
D
8N turns over but won’t start
What "old" said in order! You may want to check radiator, hydraulics and motor oil levels just in case you get it started. Check fuel tank and make sure plenty of fuel, gravity fed. Check wiring and make sure nothing disconnected, check for battery voltage at the coil. Start with 4 steps "old"... -
D
Compression test results
I believe that was the issue, no timing marks. Thanks- Dwd14329
- Post #30
- Forum: Ford 9N, 2N & 8N
-
D
Compression test results
Factotum, I was told on this forum a timing light couldn't be used because absence of harmonic balancer on thd 4 cyl flathead. What type of timing light do you use and how? I did check timing per the manual method, it was correct as far as I could see. I'm interested in a timing light method.- Dwd14329
- Post #28
- Forum: Ford 9N, 2N & 8N
-
D
Is solenoid correct or not? Can i wire it?
I see it now...- Dwd14329
- Post #47
- Forum: Ford 9N, 2N & 8N
-
D
Is solenoid correct or not? Can i wire it?
Understood Factotum 👍- Dwd14329
- Post #46
- Forum: Ford 9N, 2N & 8N
-
D
no spark
That's what I've learned from this forum. My tractor runs good at those gaps.- Dwd14329
- Post #29
- Forum: Ford 9N, 2N & 8N
-
D
no spark
Is my manual wrong? My 2N was converted to 12v so is their a difference? .015 or .025 gap for plugs? This manual is referencing original 6v. 015 gap for points.- Dwd14329
- Post #26
- Forum: Ford 9N, 2N & 8N
-
D
6volt coil in 12 volt system?
From my experience, i Bought a condeser and a coil, both were bad out of the box. You can check resistance on a new coil but it doesn't tell you if it's bad. Lesson learned myself. You can't test a condenser alone. Maybe a bench test will tell you if condeser is bad or good. My only...- Dwd14329
- Post #9
- Forum: Ford 9N, 2N & 8N
-
D
Is solenoid correct or not? Can i wire it?
No, It doesn't have a seat switch Factotum. I agree, a clutch switch would have been nice but then again the era was almost 80 yrs ago. Surprised they have any safety at all. You know, the old switch is still installed, I don't know if that has anything to do with safeties still working or not...- Dwd14329
- Post #43
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy