Recent content by G. Austin

  1. G

    '75 JD 830 tire wobble

    Oops, I read it as 850, not 830, Sorry. Gary
  2. G

    '75 JD 830 tire wobble

    I experienced a similar problem with my 1050 a couple of years ago when front wheel wobble developed on smooth surfaces in high gear. It turned out to be too much end play on the front axle pivot. TM-1192 tech manual for 850, 950 and 1050 tractors calls for 0.000” to 0.005” end play...
  3. G

    Clutch driver

    I pulled the clutch driver from a 530 a couple of weeks ago. I used a short piece of square tubing as a puller. I drilled two half inch holes in the tubing spaced the same as the hole spacing in the clutch driver. Half inch capscrews went through these holes and into the clutch driver. An...
  4. G

    950 w/yanmar diesel

    Intake and exhaust are both to be set cold at 0.15 mm (0.006"). This information is from John Deere TM-1162 manual which covers everything on the 850, 950, and 1050. I bought this manual in 1984 when I bought a new 1050. Unfortunately JDParts says that this manual is no longer available.
  5. G

    530 Fuel sender

    You might try Jerry Trcka at EverGreen Restoration. (715-635-8629) He's a good guy to do business with. I sent my 530 fuel guage to him last week for restoration. I also sent my sender to him so he could check it against gauge. He said if there was a problem with the sender that he had...
  6. G

    Phosphoric acid gas tank

    I have read many discussions about cleaning the inside of gas tank with phosphoric acid but no mention of outside. The inside of my 530 tank is clean but there is surface rust on about 50% of the exterior. This is the result of 49 years of West Tennessee climate on a tractor always kept under a...
  7. G

    530 water pump

    To Mike M You were dead on with your info. My clip was so rusted and brittle that it broke even though it had been soaked in penetrating oil for a week and I made a puller to fit down in the throat of the clip. I drilled a 0.125 hole down to the hidden end of the broken clip and pushed it out...
  8. G

    530 water pump

    I am wanting to replace the seal and bearing in a 530 water pump. I have repaired several new generation and later pumps but the two cylinder pumps are configured differently. I know that pumps are easily destroyed if they are not pressed correctly. Does anyone have experience with these and...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top