Recent content by gidtex

  1. G

    Hard starting 4020 diesel

    I got two 12 volt battery 800 900 cca in my. Gear reduction starter, 2/0 welding cable, copper battery terminal for 10- 15 year haven't had a problem yet. Battery are 800 900 cca each.
  2. G

    67 4020 injector pump

    Today after driving thru gate I left it idling while closing gate, got back on put in fifth gear went i release clutch tractor rpm went up like I pull throttle down but I never touch throttle. Thanks
  3. G

    67 4020 injector pump

    Rebuild pump 2018, is there anything else that would cause it to rev up went starting beside flex ring in pump.pump doesn't have alot hours. Thanks
  4. G

    12 volt on 4020

    I put generator pulley on alternator, both have the same I d. Now I have 1/4 inche clearance between fan and pulley. Thanks
  5. G

    12 volt on 4020

    Changed 4020 from 24 to 12 volt.used 3 wire delco alternator.problem I got is fan blade hit the alternator shaft. Alternator has one belt pulley but is not a sheetmetal pulley, it look like a machined pulley. Thanks
  6. G

    Por 15 fuel tank sealer

    Per por 15 product support , por 15 will stick to sandblasted tank. U must prepare tank with cleaner decreases, metal prep before using sealer
  7. G

    International 384

    Got a 384 fuel tank 2 pin holes on bottom from rust, thinking about cleaning inside then sandblast inside with 50 60 psi.they braze the pin holes,clean sand out tank.pour murtic acid into tank and rotate tank to coat inside with acid.flush tank with water and baking soda,flush tank with...
  8. G

    Farmall starter

    Found on goggle the starter was used 1939 -1944 farmall a b I only seen one braze or bronze it was on drive end. I measure bore on brush plate had about 6 thousand between shaft and bore first one I've seen with one bushing
  9. G

    Farmall starter

    Did the early delco remy starter have only one shaft bushing. Starter # 1107021.starter was on farmall super a 1954.thanks
  10. G

    1955 JD Model 60 Carb - What Model?

    I believe my 54 has a 81
  11. G

    JD4020 Part Id

    Engine oil cooler
  12. G

    What is this wrench?

    Look like a wrench we used on farmall h bedder
  13. G

    JD 4010 battery box

    I made my own for 4020 using 1/8 inch metal. We
  14. G

    Critter Deterrent

    Mix cornmeal and baking soda.i use cornmeal that has honey in it.
  15. G

    Lead washers

    Buy lead roof boot at home depot or loews and make your own. All u need is hole punch set.that what I use to make my lead washer for john deere 60 cylinder head.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top