(800) 853-2651
SHOP NOW

Recent content by ILL Turkey

Yesterday's Tractor Forums
  1. I

    Sherman hi/lo

    I just might have what you want, not need! I think I am going to part out the 43 2N that I was given. It has a sherman. Would have to let trans and sherman go as 1. I live in NW Illinois if you are interested.
  2. I

    Got a free one

    Picked up a 43 2N ser#9N107490 for free. Grill is gone, rims are bad, hydralics are out of it. Tin is ok, motor turns and it has a Sherman 3 speed. Question is do I part it out or keep it for parts for the 9N that I use on my property. If I part it out, how do I do that? Thanks for the help.
  3. I

    9n/8n Will not start/now it will

    Thanks for all the help. Problem was the Coil, causing weak spark. There is a difference between white and blue spark. Enjoyed installing new points on the kitchen counter. Carb rebuild pretty straight forward. Learned a lot hope I can remember a little. Thanks Again to all
  4. I

    9n/8n still won't start

    6 volt system. No work done on tractor before this happened. "loading up" kinda running slow, I was using the tractor at idle speed, like getting too much gas in the cylinders and not burning it. Spark was checked while the engine was cold.
  5. I

    9n/8n still won't start

    9n with 8n motor, front mount dist. While working tractor at idle it seemed to be idelint low, or maybe loading up. Shut it down it woule not start. Have changed points, condensor, rotor, and carp. REbuilt carb. Two questions. When setting float I set it to the gasket surface without the...
  6. I

    9n/8n Will not start

    1941 9n with 47 8n motor, front mount dist. Working the tractor a few days ago and it seemed to idle a little lower than usuall, almost like it was boging down. Shut it down and would not start again. Changed plugs, points, condensor dist cap and rotor. White hot spark from the plugs. Fuel...
  7. I

    Govenor Spring

    I have 9n with an 8n motor, front mount distributor. The sping i refer to is the heavy spring attached to the govenor and the arm that holds the lingage to the carb. Sorry for not being more clear in the first place
  8. I

    Govenor Spring

    I have 9n with an 8n motor, front mount distributor. The sping i refer to is the heavy spring attached to the govenor and the arm that holds the lingage to the carb. Sorry for not being more clear in the first place
  9. I

    Govenor Spring

    I get no response from the first quadrant of the throttle. Checked govenor spring. no tension at the idle position, infact it is loose. Ordered a new spring. Now i know this is basic, but I can not get the old one off and I concerned that if I do get it off how the heck am I going to get the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top