(800) 853-2651
SHOP NOW

Recent content by isuvinny

Yesterday's Tractor Forums
  1. I

    4440 hydraulic oil leak update

    I finally had time to look at the oil leak. It looks like the line that comes out of the differential lock under the dash is the problem? That line was covered and oil is on the floor of the cab. I took that line off - I can't really see anything wrong with it? But maybe when under pressure...
  2. I

    4440 hydraulic leak

    I have had a small seep of hydraulic fluid coming out somewhere under the remote levers in the cab. Last night I moved the tractor and when I parked it - it dumped a bunch of oil out. Something must have finally given out? How do I get in there to figure out what is going on? Is there access...
  3. I

    JD 3010 gas.

    We have been using our 3010 on an auger and the battery was getting weak so we put a charger on it and accidentally arced it when hooking it up. Now it won't turn over at all. Is there a fuse somewhere we blew? (this is 12v positive ground). It may not have been charging properly? How do I...
  4. I

    1951 B water pipe

    I am replacing the radiator core and also need to replace the upper water pipe. Are those pipes welded into the cast? or brazed? How do I get the old pipe out of the cast? Thanks for any suggestions.
  5. I

    1950 B

    I have a B with the radiator shot and upper water pipe shot. I have the hood off and everything except the radiator. Does that all come off as one piece? Then can it be re cored? Also, how do you get the pipe out of the cast piece? Heat it? Thanks for any suggestions.
  6. I

    6000 sprayer pump

    Your plumbing looks much cleaner than what I have. What valves did you use in the cab? Are they manual? Or electric? Thanks for the reply and picture.
  7. I

    6000 sprayer pump

    Your plumbing looks much cleaner than what I have. What valves did you use in the cab? Are they manual? Or electric? Thanks for the reply and picture.
  8. I

    6000 sprayer pump

    I bought a 6000 sprayer last fall and could not get the pump to prime so I drained everything and am now looking into it. I took the pump apart and it turns easily and other than some rust looks ok. There is a plug about 1/2 way up that I could put a small line in and run it to the tank. I...
  9. I

    New Holland 268 baler

    Thank you!!
  10. I

    New Holland 268 baler

    I have a broken knife and I found knives with shims online but I dont know which bearings to get. There are a lot online and the prices vary quite a bit. I prefer aftermarket to save a little $. This baler doesnt do many bales anymore. Does anyone have part numbers for the rollers? Thanks.
  11. I

    New Holland 268 baler

    Has anyone pulled the plunger and replaced knives and bearings on a New Holland 268? I have watched a couple YouTube videos on it and it looks doable. I would appreciate any suggestions. Thanks.
  12. I

    1950 JD B radiator

    I need to replace my radiator. Do I need to take the steering wheel, exhaust, air intake and hood off to get to it? I have the small front side panels off but I dont think that is enough to get to it. I would appreciate suggestions on how to go about this. Thank you!!
  13. I

    what model is this?

    That helps a bunch. Thanks!!
  14. I

    what model is this?

    I have an older 5 foot 3 point rotary cutter. The serial number is AW 25206 M85. I don't see a model number anywhere? I have not found anything online that identifies it. Is this a 513? I see some of them on Tractorhouse - and mine looks like that. Last summer I sheared several shear...
  15. I

    Sprayer drops

    I'm looking for sprayer drops for a JD 6000. What do people use? I see Tee Jet 15 inch drops are readily available. Is that the best option? Does anyone have a better idea? Thanks for any suggestions.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top