(800) 853-2651
SHOP NOW

Recent content by Jake palmer

Yesterday's Tractor Forums
  1. J

    Case 930 CK engine upgrade

    504 has a sump in the center and a bigger oil pump. I'm thinking the pump will hit the pan even if I change the pickup tube. I'll check out that group. Guess if it really came down to it i could fab up some side rails.
  2. J

    Case 930 CK engine upgrade

    Finally got around to pulling the 504. I was planning on using the 930 401 oil pan but realized that the oil pump is quite different on the 504. Would I be ok to use the pan and pickup tube off the 504 or do I need the stiffness of the big cast pan on the 401? If so is there a different oil pump...
  3. J

    Case 930 CK engine upgrade

    Hoping just a head gasket. Be pretty simple to do them while the engine is on the floor.
  4. J

    Wheel clamps

    my power adjust versus a picture I found of a standard wheel. hub looks the same just has the clamps that are different
  5. J

    Wheel clamps

    Oh crap that's not what I wanted to hear. I was thinking since they came with both wheels as an option the hub would go either way and the clamps were just different.
  6. J

    2470 504 pushing out coolant

    I was going to unhook charge pipe but got thinking if the intercooler was failed enough to leak with almost no boost pressure it would surely leak water back into the intake when not running. Has to have either a bad head gasket or cracked liner. ill o what you suggested with the water manifold...
  7. J

    Wheel clamps

    Have a case 930 CK with 34” x 16” power adjust wheels. One is junk and the other is not far behind. I have some regular wheels with good tires off a 2470 I want to put on it I just need the wheel clamps to go with it since the 2470 is a smaller hub. Anyone know the part number for the regular...
  8. J

    Case 930 CK engine upgrade

    Any thoughts on why this 504 I got is pushing coolant out the overflow? I tested for combustion gasses in coolant and it passed but is definitely bubbling like crazy.
  9. J

    2470 504 pushing out coolant

    Pulled the t-stats and one is stuck open.
  10. J

    2470 504 pushing out coolant

    bubbles in Tester when engine is up to temp and idling. No color change in fluid. After shut down it gurgled, bubbled and puked into the tester causing it to overflow. Could there just be air trapped in the system? Thinking I’ll look at the thermostats and make sure they have the vent hole in...
  11. J

    Case 930 CK engine upgrade

    This has screw in injectors so I’m guessing they updated the heads at some point.
  12. J

    2470 504 pushing out coolant

    Should that show up with the block tester?
  13. J

    2470 504 pushing out coolant

    I dug a 2470 out of the weeds That had been sitting for years. supposedly had power shift issues so they parked it. Got it for $500 and drove it about 5 miles to my shop. planning on swapping the engine into a 930. It runs great but is pushing coolant out the overflow on the radiator. Not...
  14. J

    Case 930 CK engine upgrade

    Found this 2470 a few miles from my shop. 7k hours but turbo and heads are unpainted so I’m thinking it’s probably been rebuilt. Trans issues but should run and drive enough to get it to my shop. Got it for $500 so figure I can’t go wrong. So if I understand correctly this will have the big...
  15. J

    Case 930 CK engine upgrade

    there is a 2470 for sale for $2500 about 5 hours from me. Has decent tires, duals, and seems to run good. 3500ish hours. Might be a decent donor.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top