(800) 853-2651
SHOP NOW

Recent content by johnyquest69

Yesterday's Tractor Forums
  1. J

    Galvanized Pipe Connector

    Hello all. My hot water line is leaking under the slab. House was built probably late 60's. I am trying to run pex overhead. Tore out paneled wall on back side of shower. 1/2" galvanized coming up through slab to mixing valve I can't get to. Was thinking of cutting pipe and trying to thread with...
  2. J

    Cummins 5.9 Injector Pump

    What about that pump? Do you think it will work? Looks the same and off similar horsepower.
  3. J

    Cummins 5.9 Injector Pump

    Started getting metal in my fuel shut off solenoid. Ran it for quite a while without a lift pump. My buddy tells me that probably caused it. Will probably take a full rebuild.
  4. J

    Cummins 5.9 Injector Pump

    You can see from this pic that he has it listed wrong. Still think it would not work?
  5. J

    Cummins 5.9 Injector Pump

    Thank you! Appreciate the advice!
  6. J

    Cummins 5.9 Injector Pump

    Thanks for the reply. Going to try and upload a photo of both.
  7. J

    Cummins 5.9 Injector Pump

    Good morning all! I have a Case IH 5690T that the injection pump has went bad on. Was scrolling Fakebook marketplace and happen to come across a rebuilt one. The plate on my pump shows 460426154. The plate on that pump shows 460426141. They look the same. It states it was used for testing on a...
  8. J

    JD7810 Split Stands

    Can anyone show or tell me about their split stands for the 7810? I have rolled the back away on 4430’s with a floor jack but thinking I may need to do this a little different. Thanks for any info.
  9. J

    JD7810 Not Moving

    Thanks for all the info. I’m looking into all. Will post update!
  10. J

    JD7810 Not Moving

    Got manuals coming. I did have gauges hooked at system and lube ports on bottom of tranny. Tried diff lock, but didn’t do any gear shifting. Didn’t have anything so stopped until I could get more info. I haven’t verified but thinking steering, brakes, and scv ok means splines not stripped. First...
  11. J

    JD7810 Not Moving

    Screen was clean. Could have been cleaned before it was carried to sale.
  12. J

    JD7810 Not Moving

    Gauges showed nothing on system and lube. Would my steering, brakes, and scv’s be working if splines were stripped. Trying to decide what manual I need.
  13. J

    JD7810 Not Moving

    Hello all, I acquired a 7810 and it quit moving on me. 16 speed power quad. The transmission pressure light came on with the stop light. I stopped and now it won’t move. Brought it home on a trailer and drained the oil. Found some chrome looking flakes in plug, but not a lot in the oil. Oil did...
  14. J

    4430 Clutch Operating Piston

    I posted earlier about SCV’s getting slow after an hour or so with PTO running. After some of the advice I received here and there, I split it and found oring broke on pto operating piston. Looks like I see a little wear on piston itself but JD wants $780 for this baby. How many of these have...
  15. J

    4430 hydraulics slow when pto on

    Well I tested all pressure test ports ok. My book tells me to take clutch valve housing off and blow compressed air into each port to determine bad circuit. The book also tells me that if all pressures tok, then it is a clutch valve circuit. I think it’s the pto operating piston seal, but wanted...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top