-
KKCM replied to the thread At my wits 2Nd.Check the resistor on the dash. Remove and clean the terminals on the resistor, the attachment nuts, and wires attached to it. The...
-
KKCM replied to the thread '45 2N Funk question???.Same plugs, points, and coil as a side mount distributor 1950 8N up to 1964 Ford tractors. Also the same as Ford cars and trucks from...
-
KKCM replied to the thread Rebuilding Funk 8N Governor.Congratulations on your inheritance. Funk used the stock 8N governor with the Funk custom pulley and Funk front mount plate. The...
-
KKCM replied to the thread Flathead 6 Cast Iron Oil Pan Funk Starter Drive Unleashed.My first thoughts are yes it is the same and no it is not. It might have the same gear and overall size but is the spring wound the...
-
KKCM replied to the thread 1954 Ford 630 exhaust.That connects to the horizontal muffler outlet at the front of the tractor, where the horizontal exhaust pipe would. So it uses the...
-
-
KKCM replied to the thread 1954 Ford 630 exhaust.Just need one of these, then a piece of straight pipe to extend it vertically...
-
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy