(800) 853-2651
SHOP NOW

Recent content by KK560

Yesterday's Tractor Forums
  1. K

    WANTED: Ford 5000 Gasser

    I'm looking for my Grandpas open station, wide front Ford 5000 gasser with a Ford loader. It was located in Wesley, Iowa and sold between September 2012 and March 2013. The buyer was located somewhere in the eastern half of Iowa.
  2. K

    WANTED: Ford 5000 Gasser

    They were louvered, and it was a 1968 model.
  3. K

    WANTED: Ford 5000 Gasser

    It was a general purpose chassis.
  4. K

    WANTED: Ford 5000 Gasser

    I'm looking for my Grandpas open station, wide front Ford 5000 gasser with a Ford loader. It was located in Wesley, Iowa and sold between September 2012 and March 2013. The buyer was located somewhere in the eastern half of Iowa.
    • KK560
    • Thread
    • Replies: 5
    • Forum: Ford
  5. K

    3020 Gasser Electrical Issue

    Thanks! I just bypassed that whole part and ran a jumper right at the connector at the solenoid.
  6. K

    3020 Gasser Electrical Issue

    I found that, disconnected it and ran a jumper on the connector for testing purposes and that didn't make a difference. Where do those two wires run to?
  7. K

    3020 Gasser Electrical Issue

    I can't get the starter solenoid to get power from the push button. I've changed the solenoid, the key switch, and push button. It'll start and run if I jump the contacts on the solenoid. Before I changed all the parts, it'd be a gamble whether or not the button would do anything. I know it's...
  8. K

    3020 Gasser Electrical Issue

    I can't get the starter solenoid to get power from the push button. I've changed the solenoid, the key switch, and push button. It'll start and run if I jump the contacts on the solenoid. Before I changed all the parts, it'd be a gamble whether or not the button would do anything. I know it's...
  9. K

    David Bradley 3 Bottom

  10. K

    David Bradley 3 Bottom

    It's a pull type. How do you tell the difference in the blacksmith and throw away shares?
  11. K

    David Bradley 3 Bottom

    Did David Bradley make these themselves or did some other manufacturer make them? What were the models? Can you still get parts for them somewhere or are they interchangeable with another brand?
  12. K

    What make might this plow be?

    I've had several other local farmers look and nobody can identify what make my plow is. I need parts but have no idea what make it is. Here are a few pictures. <image src="http://forums.yesterdaystractors.com/photos/mvphoto24450.jpg"/> <image...
  13. K

    560 diesel rpms

    How can I get more rpms on my 560 but keep the same idle speed?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top