Recent content by kwm219

  1. K

    MF 356 Shovel Loader

    Thanks chuck, what all does the owners manual include? A general overview and maintenance tips? Does it get in depth at all on skimatics drive train brakes and hydraulic systems?
  2. K

    MF 356 Shovel Loader

    Wondering is there is a 356 guru out there that could answer some questions for me on this beast. Perkins Deisel model am wondering how huge of chore brakes are? if there is an external adjustment or how they are done? They seem to kind of be a unicorn, not much info on them out there thanks...
  3. K

    1650 killing after 20 seconds

    it didnt" at all, had it all taped off
  4. K

    1650 killing after 20 seconds

    yes, it just seems like the float isn"t filling like it should, once it goes empty it dies and after a while of filling it will run again for a short while, not sure if that is what is really happening but that is what it seems like
  5. K

    1650 killing after 20 seconds

    nothing sexier than fresh paint
  6. K

    1650 killing after 20 seconds

    Just got done painting my 1650, looks beautiful but after getting it all together it will start and run great... for about 20 seconds then it dies. i had the tank off so it is possible that some junk got stirred around and is now in the carb. my question is, is it possible the float is stuck or...
  7. K

    6 volt / 12 volt coil 1650

    the posotive post on my 1967 oliver 1650 gas coil bust off yesterday, went to Tractor Supply and grabbed a 12 volt coil as it is a 12 volt system but when i took the old one off the tractor i saw it was only a 6 volt coil. Is the 12v the correct one or why was there a 6v on the tractor? does it...
  8. K

    help finding neutral 1650 ????

    hopefully pic works this time
  9. K

    help finding neutral 1650 ????

    here is a pic of where the rails are sitting right now, is it possible the rails are in the right place but the forks are wrong? thanks
  10. K

    help finding neutral 1650 ????

    I replaced the left shift rail on my 1650, throwing it all back together now but while replacing the rail i lost where neutral was, does anyone know any quick tips to help me get everything lined up again? I had the top put back together and the shift rail put back in, could shift between the...
  11. K

    1650 fluid help

    just wondering if someone could give me a quick run down on all the different fluid reservoirs on an Oliver 1650 gas hydrapower, how to check them and what fluid to use, (trans, hydraulic and so on) thanks
  12. K

    pto shaft removal 1650 gas

    removing motor in 1650, once the pto clutch (dual speed) is removed does the shaft just slide out the rear? are there any tricks to getting it out? thanks
  13. K

    1650 coolant in the oil

    Thanks for the advice, i really appreciate it
  14. K

    1650 coolant in the oil

    How big of a job is that to replace o-rings? is it worth me throwing in a head gasket just to see if that fixes it and then go from there? thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top