(800) 853-2651
SHOP NOW

Recent content by ljm

Yesterday's Tractor Forums
  1. L

    Removing damaged quill shaft #25 how

    How did you get it moving?
  2. L

    Psb injection pump seal kit

    Thanks everyone
  3. L

    Psb injection pump seal kit

    I have a Cockshutt 550 with a psb injection pump. I am looking for the seals. Either orings or the square rings to seal the hydraulic head. Does anyone know where I can get them? Thanks Lloyd
  4. L

    PSB injection pump hydraulic head replacement

    My Cockshutt 570 starts good cold, runs amazing but won 't start hot. I am assuming that the plunger in the h]pump is worn enough It wont pump enough fuel to start hot at cranking speed. Has anyone ever tried on of the military heads off ebay?
  5. L

    1750 Front Tires

    You will see very little difference in drawbar height. Going from 18s to 15s raised mine less than 1/4 inch
  6. L

    1750 Front Tires

    I swapped the 7.5 x 18 fronts on my 1850 for 7.5 x 15 fronts. I only use the tractor for antique tractor pulling. The front end sits lower. It steers fine.
  7. J

    gasket sealer?

    I am replacing the head gasket on a 1960 diesel fordson super major, i am new to this kind of work and i ask, do i need any kind of gasket sealer like permatex for the head gasket, manifold gasket, thermostat gasket or valve cover gasket?
  8. T

    Chouteau Pull Results are Posted

    I finally got the results posted for Chouteau Okla pull. Sorry for the delay. Don't forget the pull tomorrow at Wagoner at 5:30. Results
  9. C

    John Deere 4630 quad range

    I have a John Deere 4630 I just bought 6200 hrs on it and when I m in c range and shift from 2 to 3 it will pop out of c range and go into d range just wondering if anyone has any experience with this I m hoping an adjustment can be made or something thanks in advance
  10. L

    Cockshutt 550 diesel injection pump ( Cockshutt built)

    Thanks Diesel Tech I must not have explained the rotation correctly. My head is marked as counter clockwise rotation. Or does the rotation of the head really matter? Is the arrow on them because of a difference in the plunger? or for another purpose? My email is...
  11. L

    Cockshutt 550 diesel injection pump ( Cockshutt built)

    I am working on a Cockshutt built 550 diesel. The injection pump is an American Bosch PSB4a. The hydraulic head is a counter clockwise rotation with an 8mm plunger. The plunger in the hydraulic head is twisted off. If anyone has one, or has any suggestions where I might find one. I...
  12. L

    American Bosch PSB4a injection pump parts

    I sent an email. But it says email address not found
  13. L

    American Bosch PSB4a injection pump parts

    Where are you located? my email is [email protected]
  14. L

    American Bosch PSB4a injection pump parts

    If only the previous owner knew that I was just wondering if anyone had a used one kicking around
  15. L

    American Bosch PSB4a injection pump parts

    Hi I have a Brantford built Cockshutt 550 diesel with an American Bosch PSB4a injection pump. The plunger is twisted off. Any suggestions where I might find a replacement hydraulic head?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top