(800) 853-2651
SHOP NOW

Recent content by Mike Wheels

Yesterday's Tractor Forums
  1. M

    Farmall 2 row rear mounted corn planter

    Picked up this planter last fall. Wasnt sure if it was for an H, C or F-12/14. At that time I took measurements, and said man this should fit on the Farmall C or SC. Well today i proved it fits on the Super C. Was this planter made for the C/Super C, maybe not??? Im still not sure. I had to lift...
  2. M

    IH corn planter

    The F-14 had the hydraulic under the opetators seat. So the rods on this planter are too long for that.
  3. M

    IH corn planter

    So maybe i actually need to see the hydraulic system that lifted the H or M cultivator or planter. Did the mounted planter and culitvator for an H use the same hydraulic cylinders?
  4. M

    IH corn planter

    I recently picked up this axle mounted IH corn planter. It looks like it would fit on a Farmall C, as it has 2 rods that would go to the touch control arms. I need help finding or getting the information needed to make a sprocket to bolt on the axle that would drive the planter. Maybe its a axle...
  5. M

    Farmall C or SC, Carter Carb

    Just got a SC. Was told it had starter issues and carb could be cleaned. Starters works good. Carb was full of white goop. Cleaned that out and put back together. I cant get gas through the carb to engine. Float and needle valve are good and loose. With plug out bottom of carb gas will run out...
  6. M

    Farmall C questions

    Well I stole the electric skillet out of the house. Put 1/4 of engine oil in it. Put it on 300 degree for 3 hours. It was a brand new pulley. I had made an oak block to drive it on. It didnt take long for the oak block to not be enough. I held a 2 lb hammer against crank part and beat and beat...
  7. M

    Farmall C questions

    Gary, no body has said anything. The IT manual says to heat and then drive on the crankshaft. I dont have a torch or a bearing heater. I dont think it would benefit to use the kitchen stove. Its -9 right now, by the time i heat it to 250. It would be cold in the 100 yard dash to the shop. I...
  8. M

    Farmall C questions

    I got my governor rebuild kit from Steiners as well. I did add a washer to the rock shaft to get rid of some end play. I didnt have the right size washer to shim the bolt/shaft that goes through the housing side. I tried to do exactly what you did. Its been 1 step forward and 2 backwards on the...
  9. M

    Farmall C questions

    pictures
  10. M

    Farmall C questions

    Im doing a complete overhaul of my Farmall C engine. I see the crankshaft pulley is friction fit to the crankshaft. Is their supposed to be a bolt and flat washer to hold it on, that goes into the end of the crankshaft? Mine didnt have one when i took it apart, but I see the crank end is...
  11. M

    Farmall C battery/wiring problem

  12. M

    Farmall C battery/wiring problem

    Bought this Farmall C and the owner delivered to my house. The alternator was missing. Wiring was a complete mess. Tractor was started on a car battery, and it ran and drove. Seller took his battery back. I put in my deep cycle out of my boat. Deep cycle battery was bad. I went out and bought an...
  13. M

    Farmall SC wiring

    Is their something wrong with the 10SI single wire alternators? Or does the 10SI 3 wire work better with the old wires for the voltage regulator?
  14. M

    Farmall SC wiring

    I bought a Farmall SC with a belly mower on it. Previous owner always pulled the negative ground clamp off the battery. To prevent it from draining. Its still a 6 volt system, negative ground. I am in the process of replacing the old frayed wires on the generator and the system. Is their a...
  15. M

    IH hand crank corn sheller

    Thanks for the help and ideas. I will give it a try when i get home this afternoon.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top