(800) 853-2651
SHOP NOW

Recent content by nixonrules-HT

Yesterday's Tractor Forums
  1. N

    240D Clutch Replacement Problem

    Did you ever figure this one out? I have the same problem after replacing the clutch on my 1401D. I strongly suspect the pin on the yoke has sheared, but it don't want to split it again unless I've exhausted all other possible options. Thanks
  2. N

    Minimum trailer size for towing 1401d

    It actually has a FEL and Rototiller attachment on it, so I guess I'll have to shop for a trailer before I move it anywhere. Thanks!
  3. N

    Minimum trailer size for towing 1401d

    I was wondering what size trailers people are using to tow their Yanmars? I have a 5x10 foot single axle utility trailer with a 2000# axle with no brakes and a 1/2 ton 4WD truck. Seems like this setup might not be heavy duty enough for a comfortable safety margin. Any thoughts?
  4. N

    injector housing outside diameter??

    ah- thanks Dairyman. I think that is what was missing. I'll have to order one of those up. Thanks!
  5. N

    injector housing outside diameter??

    <QUOTE author="Arnold"><s> /e></QUOTE> The gasket is inside the injector. I did not see a gasket between the injector and the cylinder head which is where the sloppy fit was. There are 2 studs holding a cap that cinches the injector against the head- maybe that is all that holds it in? I don't...
  6. N

    1401D injector repair

    I got the injector repair completed without incident. But I now have a question regarding the injector diameter because I was able to just pull the whole injector out by hand. See my other post for details. Thanks
  7. N

    injector housing outside diameter??

    OK- I got the injector out and repaired the washer gasket. The whole injector came out and was loose in the head. I measured the injector housing diameter to be 1.0180" and the hole 1.0212" meaning there is a clearance of ~ 0.004". I read somewhere that this is supposed to be an interference...
  8. N

    1401D injector repair

    I'm replacing the top-most gasket (part number 172100-53200 on the exploded view of the injector) for the #2 injector on my 1401d. I was told when I ordered it to be careful when taking the injector apart because it is spring-loaded. Do I need any special tools or anything to watch out for when...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top