(800) 853-2651
SHOP NOW

Recent content by Organic Farmer

Yesterday's Tractor Forums
  1. J

    8n Ford Tractor Battery Discharging Problem

    I have a 1948 Ford 8n tractor. This is the first Ford I've ever owned. It's my chore tractor on my acreage. I have a problem with the battery discharging when the tractor sits overnight. It is still a 6 volt Positive ground system. If I disconnect the positive battery cable when I shut off...
  2. R

    Jd 70 axle

    Does the 70 have the same size axle as a 4020 or a 3020 trying to find 9 bolt hubs for lighter wheels to get rid of the cast centers Thanks for the help
  3. R

    ez out out!!!!

    Found me a 3/16 ball endmill amd was able to drill right through the center of the ez out. Came out like no other. Drilled the screw out alittle bigger and it came right out too. All is good with the allis!!! Thanks for all the help, Rusty
  4. D

    9n hyraulics

    Finally, got back to 9n. 3 point will lift 100-200 lbs only. Pressure test with arms chained will go to 350 psi at idle, 400 at pto speed. Lifting 100 pounds, lift is smooth as can be. Leak someplace, no oil dropping from top cover. Relief valve is good, no oil escaping there. Adapted Z...
  5. O

    5200 Cab

    I thought that Sims moved all their operations to Mexico after NAFTA opened up? Any suggestions on a tractor salvage yards that has lots of JD equipment? Thanks
  6. O

    What's it worth?

    I have a 4 cylinder Wisconsin engine that I took off of a JD 346 baler (converted it to PTO). I bought the baler with the engine but have always used a PTO and wasn't that comfortable with a stationary motor driven baler. The engine ran fine when I took it off but I have no use for it. What is...
  7. O

    Need Wisconsin engine expert

    So how much is one of these Wisconsins engines worth? I took one off of a JD 346 baler and converted it to a PTO driven now I need to get rid of this engine. Thanks
  8. O

    Tire on Ford 4000

    I recently bought a Ford 4000 and it has two different tire sizes. One side is a 16.9 X 30 and the other side is a 18.4 X 30 (it looks a bit wrinkled). What should go on it and does anyone sell used rear tires near Fort Worth, TX Thanks !!
  9. O

    Ford 3000 serial #

    I am looking at a ford 3000 with a serial # c175xxx Can you tell me what year model it is? Thanks
  10. O

    4000 maybe??

    I recently purchased what I thought was a Ford 4000, however it seems too wide for the 2000-4000 series. The model number off the frame is M4000K205 and the back tires measure 92 inches from the outside. Also the serial number starts with an A instead of a C as other models do. (A117xxx) What...
  11. O

    4000 Shifting problem

    When I try to shift gears it grinds like crazy (yes I was pushing the clutch down). Sometime idling the engine back will make it grind less but it still grinds. What would cause it?
  12. O

    Ford 4000 Model

    Also the serial number starts with an A instead of a C as the other models do.
  13. O

    Ford 4000 Model

    I just purchased what I thought was a Ford 4000 tractor, however it seems to be very wide for the 2000-3000-4000 series. The model number off the frame is M4000K205. The back tires measure 92 inches from the outside. What the heck is it? Also I want to mount an engine driven hydraulic pump...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top