(800) 853-2651
SHOP NOW

Recent content by satchmolips

Yesterday's Tractor Forums
  1. S

    MF165 Oil Filler cap dimensions

    Thanks Guys, I cant use the Allen key port as it has to be quick free flow so hence using the transmission filler plug
  2. S

    MF165 Oil Filler cap dimensions

    Hi, I am fitting a post knocker and need to put the return hydraulic into the oil filler hole by the gearstick. Does anyone know the thread size of the cap that goes in there, or have any suggestions as to how I make something that gives me a reasonable seal instead of just a dangling pipe into...
  3. S

    MF165 Brakes

    David, A few questions. With dry brakes, do I have to drain back end oil before taking of axle? I am reckonong on new actuators and discs. I guess there will be a gasket each side. Will there be any additional seals I would need? And an earlier question, do I do anything different with diff lock...
  4. S

    MF165 Brakes

    Hi David, Yes to UK (Worcester). Many thanks for reply. I will check adjustments but think some new parts will be necessary. Really helpfull response, I was unclear about axle removal but get it now. Do I have to do anything different on diff lock side or take off just the same?
  5. S

    MF165 Brakes

    Have a 1960's (H Reg) dry braked 165. A little left on offside, none (pedal falls loose) on nearside. Need to do thje job. Could do with an A-Z of the task and a likely view on parts required if anyone can help please
  6. S

    MF135 Electrics

    MF135, early swept axle type. Sorting out the lights on this. It has rear lights on mudguards (red back, white spot type front of mudguards) and a plough lamp. There is a loom around mudguards with a set of connectors at base of right hand mudguard. But there is no feed to this from anywhere. I...
  7. S

    Hydraulic pressure MF230

    Does anyone know what operating pressure the hydraulics will be from the trailer tipping connector on an MF 230, BAR or psi??
  8. S

    Hydraulic help needed please

    Thanks all, Have found the return plug mentioned. To be clear I have a double acting cylinder. I will fit a double acting spool valve, which needs a flow and return from tractor, so there should only ever be one flow back of oil. Re speed, why should this be any different to a loader? I have...
  9. S

    Hydraulic help needed please

    I wish to run a hydraulic log splitter off either a MF230 or MF265. It has a two way ram so I will need a flow and return. Both tractors only have the single hydraulic output to tip a trailer. Is there a simple way of providing a return? (Tap into a cover somewhere, unless there is somethig...
  10. S

    MF165 Injectors

    Hi, Is it possible to take the injectors out (for service) of a 165 without taking the tank off? It looks like ther may just be room but I dont know how far they go in!
  11. S

    MF 165 Cylinder Head Plate

    Hi, Seem to have developed a dribble of coolant from the plate at the steering wheel end of cylinder head. It has six bolts attaching it to head. I assume there is a gasket underneath it? What's it for and is it a simple on and off job??
  12. S

    MF Heating Plugs

    MF 135, MF 165, MF265. All of these have the heater plugs which are switched by main ignition key and have diesel dribbing into them. Some of the replacement plugs have a spade connector on them and some have a threaded screw type connector on them. The latter are about £7 cheaper at my local MF...
  13. S

    MF165 Power Steering Pump

    OK Many thanks again David
  14. S

    MF165 Power Steering Pump

    Thanks Dave, I am using the red power steering oil. Is that OK? I am aware re the filling procedure. So it is probably the filter needs a look at. Presumably the nut on the back of the housing undoes that. Are there any seals or gasket i will need if I take it apart?
  15. S

    MF165 Power Steering Pump

    Hi, Is there any reason why the steering pump oil should come out of the breather on the top of the power steering pump. It seems to get blown out slowly. Could it be the cold weather, or is there a filter in there that may get blocked? No leaks anywhere else at all
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top