Recent content by Shawnba67

  1. S

    hand clutch(liquid coupler)

    So i have an old d15 that ive been repairing and using around my farm. i normally only use first or second gear. The other day i put it in 4th for giggles and pulled the hand clutch back it was for lack of a better term slipping a bit as tractor got moving. So my actual question is is the...
  2. S

    Question on abnormal use of a disc

    I have an 8ft wheel disc I pull with my D15. I want to remove one side front and rear disc gangs to make it a 4ft disc to prepare a garden spot. Will it work ok for this non standard use? If it will pile up the dirt to one side is there a way to know which side it will put the pile? My buddy...
  3. S

    D15 cold starting

    I found what I thought was a good AC number for the points of 1855720 my local napa crossed these to a CS763P. The napa ones look quality. Tractor runs quite a bit better now the old points were cooked. It did start at 30 degrees this morning with no issue so hopefully I have it sorted out!
  4. S

    D15 cold starting

    So today I tore the dist cap off and checked the points, they had opened up a smidge and had a burnt spot so i sanded them clean and readjusted. This seemed to make a noticable difference in the idle, and possibly anecdotal but my black smoke on acceleration is greatly reduced. Hopefully my guy...
  5. S

    D15 cold starting

    So last year my tired old d15 would fire up and run every time I asked it to did not matter how cold. This year I had to rebuild it new pistons liners and had the valves ground. And this morning at about 29 degrees it took a half hour to get this ole girl up and going. When it was warmer I had...
  6. S

    D15 differential carrier cross pin bolt head missing

    Man that is fantastic news!I had pre-given up on getting out a headless bolt!
  7. S

    D15 differential carrier cross pin bolt head missing

    So my ole 15 is getting tired. I had the pumpkin off and found a brass shim in the bottom of the pan. This shim goes to the right side axle gear. Not to big a deal it does seem like it may be fun to source but the real problem here is the head of the cross pin retaining bolt is missing!! It has...
  8. S

    PTO seal replacement D15

    So I recently decided it was time to repack my lift arm ram. I ordered the parts the place said I needed. I pulled off the rear housing and thats when I noticed the supplied pto shaft seals go way up in there. What are the odds that I will regret not replacing them? How big a job is it to get to...
  9. S

    Early D15 gas Radiator options

    I took it to the local rad repair shop. They could not fix it. They were able to procure a replacement that they say is identical. I will find out Monday morning. Man this bit of oopsy is expensive!
  10. S

    Early D15 gas Radiator options

    So I busted my rad! It bent a little and appears to have 6 or 7 leaks. All the replacements show serial above 9000 mine is an early. What options do I have? Anyone know what part number the early calls for? I do not need it to look original this ole girl is still at work. Thanks much
  11. S

    AC 149 eng Running temp

    It was apparently just heavy load while hogging that 4ft tall grass been hanging out at 170 under normal use.
  12. S

    My first time

    I have seen several were a steel hose bracket will rust between the hose and the bracket, pinching the hose closed. Pry it back open and go another decade!
  13. S

    Unhook lift arm hydraulics?

    Any seals for the pto or anything?
  14. S

    Unhook lift arm hydraulics?

    Could you tell me what parts I will need on hand to do the cylinder repacking job? I have ordered new cylinder packing, are there more seals or such I will need? Is the hose a one of a kind or can I likely get one at my local farm store? I did recently finish the in frame rebuild now its time...
  15. S

    AC 149 eng Running temp

    Is it normal for a AC 149 gas engine to run above the thermostat temp? I just did an in frame on an ole D15 that did not have a thermo in it previously(former owner no idea why) It warms up to 170 and stays there until I put a load on it then goes up to just shy of 200. I did try richening up...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top