(800) 853-2651
SHOP NOW

Recent content by Silverfox 1

Yesterday's Tractor Forums
  1. S

    Farmall V8 Pulling

    We pull with the thumb tractor pulling assn.here in michigan 5700 lb v 8 hot rod class 410 ci small block power plant must use tractor trans and rear end 20 inch draw bar 18 4 38 tires .
  2. S

    looking into my crystal ball

    Well you can have all the horse power you want but you still have to get it to the ground and that where a needle bearing rear end comes into play.
  3. S

    Silverfox 1 - Exhibition Pulling

    Thank you for checking into this for me. you folks have a safe and fun pulling season.
  4. S

    New Pewamo, MI Track

    little bit of antifreeze we over filled it they shut us off because of it
  5. S

    New Pewamo, MI Track

    My tractor is TTPA and COATPA registerd and has all the safty equipment it is 410 ci ford power and track speed is about 23 mph I Would gladly pull xibition and pay what ever entry fee you folks require i just need somewhere to test .
  6. S

    New Pewamo, MI Track

    Where is Pewamo mi and would you allow a v8 hot rod oliver to pull there
  7. S

    rear end

    Any of you pullers that want a price on a rear end give me a call at 1 586 651 8851 im in michigan and my name is Wayne
  8. S

    rear end

    Does anyone in the pulling world need a needle berring carrier for there pulling tractor i can set you up . All the power in the world wont do you any good if you cant go stright down the track.
  9. S

    Tallmadge Photos

    Are they big block v 8s and what rules do they run under
  10. S

    Broughton Tire cutting

    My two cents, Isend all my tire cutting and sharpining to Jermey at me miller always treated me good and on time.
  11. S

    Winter

    Well u could check us out on facebook at silverfox tractor pullimg team or here is a picture this eas eaton ohio 2010 we were the highest placing michigan tractor in that class and took 4 th overall...
  12. S

    Winter

    Yes it is 60 inch wide now , i do have weights and chains for it but i havent had to put them some day when i get time away from workin on our pullin tractor i will paint the ole girl
  13. S

    Winter

    Just a picture of my super A .I had a local canvas shop make this winter front it keeps the motor temp up and the carb from freezing .I also use blue stabil and dry gas, i havent any trouble with starting or runing and it is 6 volt,it works for me and the neighbors love it.
  14. S

    V8 Antique Hot Rod

    410 inch small block we made our own slide coupler ie driveshaft the tractor is on u tube eaton ohio v 8 hot rod tractors or papa bervile it was the highest placing michigan tractor at eaton 2010 you can check us out on face book also under silverfox tractor pulling team
  15. S

    V8 Antique Hot Rod

    My father and i run a v8 ford in a oliver 88 we built our own frame from the transmission foward, we also run a slipper clutch and scs gear box .
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top