(800) 853-2651
SHOP NOW

Recent content by spitz

Yesterday's Tractor Forums
  1. S

    Pacer oil pressure low

    Lines seem clear as oil comes out of them if I disconnect. This is my third gauge and reads about 4 psi now. Even with 15w45 oil in it. The relief valve has no effect on pressure. Is this normal for low pressure or should I see a change when I add washers to it?
  2. S

    Pacer oil pressure low

    I have a pacer that the motor was rebuilt-pistons/rings/ bearings etc. Runs good but only has 4-10 psi oil pressure. Messed with the relief spring and got no change with 0-6 washers. Is there anything besides bearings to look at?
  3. S

    Massey 175 transmission top cover

    I just tore apart a 175 and put in a new hydraulic pump. When I put the top cover back on what will I need to watch out for? Will I need to recalibrate or readjust anything since we didn’t mess with any of the top? I have read some horror stories and would like to avoid them!
  4. S

    Egg washer- anyone know anything about this one?

    Picked up this egg washer after looking for years. Has anyone here used one or know anything about it? Would like to fix it up. It is from brower mfg is about all I know. How does the water hook up?
  5. S

    Massey pony transmission help

    Got them looking but no luck yet.
  6. S

    Massey pony transmission help

    No mine is a 1949
  7. S

    Massey pony transmission help

    I am having trouble finding 850125m1. Do you know where you saw it was available? I think I have found the snapping.
  8. S

    White Iseki 2-62 3 point arms won’t go down.

    Not sure but if I remember correctly there is a valve by your feet that has to be partially open for the three point to work.
  9. S

    Massey pony transmission help

    Doesn’t look to be anything for an internal snap ring either. Not sure how they go. Not sure what #2 is. Hopefully someone that’s had one apart can help figure it out.
  10. S

    Massey pony transmission help

    That would make more sense! I will give it a closer look. My trans doesn’t have 2 or the snapring on 10.
  11. S

    Massey pony transmission help

    The shaft could move rearward but not forward. Snapring 1 held it from going forward. I don’t know if #2 or the snapring with no groove #10 is supposed to keep it from moving back? By the amount of silicon in this trans someone has been in here. Guessing this is why it got parked.
  12. S

    Massey pony transmission help

    That definitely helps. I assume the pony and pacer are the same and this is the best diagram on assembly I could find. Do you know if the front snap ring just goes on the shaft even though there is no groove for the snapring?
  13. S

    Massey pony transmission help

    Working on a pony transmission that I think is missing some parts. I have the input shaft out and it looks like there should be a snap ring by the bearing( #10) but there is no groove in the shaft for the snap ring. Is this correct? Also looking for some parts numbers. Mainly # 2,9,10,11. I...
  14. S

    Chain hoist helsp

    I recently got a three ton peerless Harrington hoist to use to pull an engine out of a farm truck. Problem is I cannot see what is missing. It moves up but I cannot find anything to allow me to lower the load. Have been soaking the pulley for weeks trying to get it off to see the mechanicals but...
  15. S

    Paint gun choices

    Looking at painting a couple Massey Harris tractors in the near future and will be in need of a good spray gun. I have the harbor freight options and their black widow line or a devilbliss starter line kit in mind. Something in that 150-200 dollar range. Anyone have experience with these spray...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top