(800) 853-2651
SHOP NOW

Recent content by Stoegs

Yesterday's Tractor Forums
  1. S

    Cylinder head

    Works Thank you
  2. S

    Cylinder head

    Any tricks on getting a cylinder head off a D17 block. Can’t budge it with brass sludge hammer or try to wedge anything in between , tried two foot pipe In exhaust holes, nothing looking for ideas. Bill
  3. S

    Serial number

    Can anyone tell me the manufactured date of a AC Gleaner e motor serial # 17-43591-m. Just wondering when it was made. Thanks Bill
  4. S

    Best head gasket

    What is best head gasket for an Allis Chalmers D17 motor, the one that comes with a gasket kit or a copper one?
  5. S

    Pistons

    Thanks
  6. S

    Pistons

    Nothing apart yet, just making a game plan.
  7. S

    Pistons

    By using WD flat top pistons in a D17 what will be the compression ratio be? Will there be any complications. Thanks Bill
  8. S

    Rebuild for D17

    I know this has been discussed before, and have read different forums and end up being confused. Gleaner E in a WD, what rebuild kit do I use, looking for.125 over and higher compression and no machining. What would be the best piston for pulling. Not planning on any other modifications. Thanks Bill
  9. S

    Gleaner E

    Thank you Sir
  10. S

    Gleaner E

    Front control rod is 26 inches, rear control is 6 1/2 inches. It could be correct, but the governors are set different for a combine and this motor is unchanged since it was installed in tractor, I think it should be changed but I have no clue. In fact I don’t know what else should be changed. I...
  11. S

    Gleaner E

    Have a WD with a Gleaner E in it, is there any dimensions on the length of the rods for the governor for pulling, I read in a forum somewhere that the combine is different than the D17. Thanks for any input.
  12. S

    Shift lerver

    Can you machine the wd45 curved handle to work in the Wd?
  13. S

    Shift lerver

    Can a shift lever on a WD be heated and bent or will it weaken the metal. To short to reach the lever☹️
  14. S

    WD shifter

    Thanks
  15. S

    WD shifter

    Can a curved shifter WD 45 be made to work in an early WD?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top