(800) 853-2651
SHOP NOW

Recent content by THOMASJOHN

Yesterday's Tractor Forums
  1. T

    Picking corn in SC

    Around April 1,-15 or so in the low country, from Darlington up to the NC line a week or two later
  2. T

    I'm in need of used JD RW disk parts 12'

    AGRI-Supply has the bearings you need 12.95 each JD 84.00 each Agri-Supply.com Tommy in SC
  3. T

    60 clutch and skip

    Hello, When I first crank up the 60 it really runs good at a idle, but if you give it some rpm it runs ruff until it has worked for a while (it takes about 20-30 minutes then it really hits on both cylinders not missing a beat. Any suggestions what can be done would be very greatful. While...
  4. T

    48 B powr-trol rockshaft operation

    hey Brad, I was told that most of the dummy plugs are interchangeable I have a 1956 60 and I had to pick some up, a friend had some that came off of a B and they work fine. Hope you get it working. My rocker will not operate with the cylinder couplers but works like a charm when dummy plugs...
  5. T

    60 cultivators

    2 or 4 what ever is available
  6. T

    60 cultivators

    Looking for a set of cultivators for 1956 60 JD. Some where on the east coast. Closer the better to SC. Thanks, Tommy
  7. T

    John Deere Disk Identification

    DEVON, Look on the outter edge face on the end of the angel of the gang holder you should see lettering of what modelit is, or it was where I found it on mine. Mine was a JD RW 10. Tommy
  8. T

    1940 Unstyled G

    660 bearing bronze is what we use at work for bushing. I work in a tool room myself and it is my responsibility for ordering materials. I believe this will do good for you. Tommy in SC
  9. T

    RW JOHN DEERE DISC (PICTURE)

    Trying to post picture.
  10. T

    RW JOHN DEERE DISC (PICTURE)

    Thanks for all the help with the tractor and disc. Tommy
  11. T

    60JD Stalling under load

    Wilmayba, About where can i find this adjustment screw, and about how many turns does the idle screws need to be backed out?
  12. T

    60JD Stalling under load

    Tractor idles good, when I start pulling disc the tractor seems to skip are something,it runs ruff Is there a load screw adjustment on it. There is a good flow of gas at the carb., Also I notice that the clutch would need to held forward when under load or it would not pull any suggestions on...
  13. T

    powewrtrol jd 60

    Het F-I-T, Thanks for all the help with the power-trol Got new spring in check valve today, o-ring in the coupler and a new gasket on for the unit. Ran pressure test and had to use only one shim to bring in the pressure to correct range. no leaks and the disc picks up just fine. Thanks again...
  14. T

    powewrtrol jd 60

    Hey F-I-T, Today I took off the power-trol unit I found that the unit did not have much oil to drain, it could have been low because of the hose blowing off. I found that the bottom check valve was not right. The ball closest to the plug was not under the spring. I put it where it suppose to...
  15. T

    powewrtrol jd 60

    F-I-T Can the power-trol be taken off without taken off the rockshaft, I understand from the service manual that this can be done. I'm going to re-do pressure test and watch for the release lever to kick to the neutral position.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top