(800) 853-2651
SHOP NOW

Recent content by timmy curl

Yesterday's Tractor Forums
  1. T

    weep hole upside down cotter key

    There is another solution, use what is called a blind cotter pin. It is designed to be inserted in the hole, then a light hammer blow spreads the ends slightly, enough to prevent the pin from coming back out. It is designed for these applications where the ends are not acessable. These pins are...
  2. T

    motor

    Good luck on finding an MD engine. MDs were rare and worth a lot. I don't know of anything else that used that engine. If at all possible, I would repair your engine, or switch it to a gas one.
  3. T

    WD-45

    I have one, I'm located by the Ky Speedway, Where are you?
  4. T

    WC finished pictures

    Very nice job! You definitely invested a lot of time and money in that one, but it is beautiful. I have a 1938 that I would like to restore but short on time and it needs rear rims. Mine has no key or electrical system, was the key and amp meter in that location originally?
  5. T

    TO30 auction find.

    I recently bought this as a no run at a local auction. I got it broke loose and running, but it didn't have a speck of paint on it, so I rummaged around and came up with this. It had new tires on the back, new belt and hoses as well as a new seat, so I figured I couldn't go wrong for 400.00. It...
  6. T

    starving for gasoline

    Missing under a load is often spark plugs, wouldn't hurt to try another set.
  7. T

    18.4x34 Tires Wanted

    I got a set of CoOps, I"ll have to check how much tread is on them, 1 is mounted, also have to check for repairs, etc.
  8. T

    Case 3230 hyd problems mEL?, anyone?

    Thanks mEL, I will start looking!
  9. T

    Case 3230 hyd problems mEL?, anyone?

    Case 3230, single remote system, remote stops working after aprox 1 hr. hyds get very hot. It has probably around 5000 plus hrs on it. The poor guy has been working on it for 2yrs, had 4 different mechanics look at it, i"m #5. They have replaced the hyd pump, cleaned and flushed the cooler...
  10. T

    880 gas top engine oiling

    Thanks, rrlund, I take it somebodys changed the head bolt.
  11. T

    880 gas top engine oiling

    Anybody know where the rocker arm shaft gets its oil on an 880 gas engine. I"m working on a friends tractor, theres no oil to the rockers, a small 1/8" steel line is connected to the rockers, but the other end is hanging loose, the head been changed?
  12. T

    Pulling pictures

    I have a DC that I have pulled for over 20 yrs, got to be the best balanced tractor I ever pulled, always competitve, I see you lean way back to bring up the front too, thsy like to pull this way for sure, thanks for posting.
  13. T

    Oliver 880 governor

    I need to know the linkage arrangement on a 880 gas governor. The governor was disconnected for pulling years ago, now it must be reconnected.
  14. T

    Melvin Bennet

    Mel, Congratulations! I look forward to meeting you, saving money for some engine work on my DC Purple Reign. Thanks for all the advice, it took no time to figure out who the Man was to go to! Some say I have too much tire, I say just too little engine, Jus wait til Mel get a hold of it!
  15. T

    Calling mEl- need help!

    mEl, I'm definitely interested in building a new engine. I t is necessary! I'm sure I'm running on borrowed time. I responded on this forum to somewhat keep it discrete, My phone # is (859)-991-9344, or send me yours, which ever is more convenient, thank you for responding.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top