Recent content by tractormuellerp

  1. T

    Farmall H - Starter stays engaged

    I have a Farmall H where the starter stays engaged. Suggestions? How do I fix this?
  2. T

    Ford 8n Paint

    Tim, When painting on the Tisco red with a paint brush. Do you just use the paint straight? Or do you had an acrylic hardener to the paint - when you brush it on? What primer would you recommend? I'm currrently working on the rims. What paint would you recommend for the inside of the...
  3. T

    Ford 8n Paint

    I'm going to start painting a 1949 8n. For ease of paint clean-up and easiness, I plan on using spray cans. The Spray paint that seems the most affordable is Rustolem Ford Red and Ford Grey. I was reading that there were three different types of Ford Grey (Light, Medium, and Dark) And...
  4. T

    Jacking up Rear end

    I plan on taking the rear tires off my 1949 Ford 8N for a while. I plan to refurbish the rims. Where is the correct place to place the jack when lifting the rear end? Where is the correct place to block the rear end? Diagram or picture would be great!!!! ;)
  5. T

    Ford Factory Rims

    I'm in the process of replacing some tires. I've found some decent used tires on original ford rims. My tires are on original ford rims as well. I noticed that the tires I'm looking at have the valve stem on the inside of the tire, where my rims the valve stem is on the outside of the tire...
  6. T

    1949 Ford 8N - Tires

    Do those two different tire sizes take different rims?
  7. T

    1949 Ford 8N - Tires

    I have a dum question - as a I am newbie to the Ford 8n world. My 1949 8N has mismatched rear tires. They need replaced and of course want to match them correctly. Back-Right is 11.2-28 Back-Left is 12.4-28 What is the correct original tire size? Is the rim the same size for both...
  8. T

    Dearborn 10-156

    Sorry forgot to mention it is a 2 bottom.
  9. T

    Dearborn 10-156

    I'm looking at buying a Dearborn plow model 10-156. The owner doesn't know much about it and it is several hours away. Did the 10-156 come in a standard size? Would it be a 12 in, 14 in, or 16in? Or does it vary? Any help would be appreciated. Thanks!
  10. T

    5 foot disc

    Does anyone know if this is Ford, Furgeson, Dearborn Disc Design? (Pictures attached) Thoughts on pulling it behind a Ford 8n?
  11. T

    Ford 8N air breather

    Went to change the wire mesh cartridges in my air breather and noticed there is a cover holding the catridges in place that has three clips. I couldnt figure out how to undue these clips and pull off the cover without totally bending and disfiguring the air breather canister tin. Was a special...
  12. T

    Oil change

    The canister drained once I pulled the plug on the canister. Didn't know if pulling the plug was required....thought maybe it would just slowly drain down the oil line.....
  13. T

    Oil change

    I did not.......
  14. T

    Oil change

    Changed the oil last week on my 8n ford. I replaced the oil filter and poured a little bit of new oil into the canister area, but put most of the 6 qts in the engine. As I was reading my operators manual it calls for adding a quart of oil into the canister. I assume I am fine, because the oil...
  15. T

    Dearborn 11-61 Disk

    Any thoughts on this Disk for an 8N Ford? Owner told me it is a 7.5 foot Dearborn 11-61. Needs 6 of the front blades replaced and a gang shaft straightened a little. To heavy or big for my 8N? Thoughts on repair cost?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top