(800) 853-2651
SHOP NOW

Recent content by WD Nick

Yesterday's Tractor Forums
  1. W

    What it worth

    This is a 1950 WD. In the last 2 years it has had the engine rebuilt, new tires, radiator, manifold, steering wheel, and a re-built starter.the old tractor has low hours on it since the make over and is being preped for new paint.It has the snap coupler with the draw bar and has a 3 pt setup. I...
  2. W

    WD-45 transmission problems

    To be honest, I would rather have a WD with a WD45 engine than the other way around. I own several WD/WD45s, and the straight cut WD has a stronger transmission. It has more surface area and runs cooler than the helical gears do. The drawback is they are noisy and tend to grind when shifting but...
  3. W

    WD 45 trans

    Is it me or is the 45 trans with the helical gears weaker than the old WD trans. Ive torn down 3 45's and they all have excess wear. I took the shifter assy off my 49 and 50 WD's and there is very little wear. My 49 has been mowing and working the farm since it was new. One of the 45's has'nt...
  4. W

    WD45 rear wheel spacing

    I put a 6 foot tiller on my 1950 WD. Its more trouble than it was worth. The first problem is that the PTO speed at full throttle is 720 RPM not 540. When the tiller is lowered into the ground the old WD launches. If you have good breaks you might be able to hold it back.The next problem is 1st...
  5. W

    Gear popper

    I have a 1954 WD45 that pops out of 1st and 3rd gear. Is this a shift fork problem and if so will the shifter assy from a 1952 WD fit?
  6. W

    WD and WD45 questiones

    If you don't use or understand the traction booster then the Allis would pull the front end off the ground. Its also been my experience that most Allis Chalmers will pull the front end up because unlike green tractors, they can. Red and green just did holes.
  7. W

    WD-WD45 ......Tire size?

    Thanks for the clarification. I thought I had the wrong tires on all 3 of my WD's.
  8. W

    WD-WD45 ......Tire size?

    The early model WD's had 11.00x28". The WD45 had a larger 13.6 or 13.9x28".
  9. W

    complete p/s unit

    Can anyone tell me what a complete p/s unit off a 56 model WD45 might be worth. This unit comes with everything needed to install on a 45 or WD.
  10. W

    splitten wood

    Has anyone used a log splitter on a WD or WD45 and had any luck?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top