(800) 853-2651
SHOP NOW

Recent content by Young Popper

Yesterday's Tractor Forums
  1. Y

    Unstyled Rims

    Kansas
  2. Y

    Unstyled Rims

    All the front rims I have are all spoked. All 3 B's and counting:)
  3. Y

    Unstyled Rims

    Is there such things as cast wheels on the unstyled tractors? I have a pair on a 37"B I just bought as a parts tractor. I have never seen a pair that had 4 bolt clamps. Mostly if an Unstyled had them, they were a later rim with the 3 bolt clamps. If so, is anyone interested in them?
  4. Y

    Powertrol Questions

    OK, I just want to check to make sure I am not missing something obvious. With the "dummy plugs" in, the rockshaft moves up and down. Can you leave plugs in that have a quick coupler if nothing is attached and still get use out of the rockshaft? My A, with dummys in it will move, but it keeps...
  5. Y

    power trol oil

    I use engine oil. Straight 30, non detergent
  6. Y

    Threads in Roll-o-Matic

    Alright guys, There is 2 threaded bungs on the front of a roll-o-matic. I was wondering if anyone knew what thread and size these are? I am beginning to beleive its a not so common size. Thanks
  7. Y

    44 A Axle Seal

    Alright guys, need to put in an axle seal. Drive off the gear and pull the whole shaft out? I am wanting to do all seals and bearings. Thanks
  8. Y

    44' JD A-Correct Rims

    I checked my frame. Its all angle iron sides, no castings. I see the difference though. So the earlier had cast, then went to angle, then to pressed?
  9. Y

    44' JD A-Correct Rims

    My tractor has a powertrol on the back, not a powerlift. I was told its suppose to be a lift not a trol? Do you want those #'s?
  10. Y

    44' JD A-Correct Rims

    Tom, That is a good looking A. The width of the frame are you talking about how much narrower yours is at the grills? Whats your plans with that thing?
  11. Y

    44' JD A-Correct Rims

    Finally read the # of the plate!!!! Some WD-40 and 2000 grit sand paper got the rust off to be ledgible. Its a late 44 judging by the run of numbers. Its 544755! A-Guru, I have the solid cast centers that the "rim ring" attaches to. If these wheels are correct, that is awesome. I just want this...
  12. Y

    44' JD A-Correct Rims

    The plate is steel. I have not tried the different angles yet. What started this "wheel" discussion was I had a 45 B that had the solid wheels. I figured these needed to be the same and not what I have. I will try to take the time to read the plate tomorrow and get back with you. Thanks for all...
  13. Y

    44' JD A-Correct Rims

    A Guru- Are you thinking it s older or? I was told its a 44'. Plate is not 100% readable. I have not spent a lot of time trying to read it either. Old flywheel start. Carries great oil pressure and starts in 2 or 3 pulls. No to painting though?
  14. Y

    44' JD A-Correct Rims

    Question, 44" Should have what style of rims? Spoke or Solid 4 Gaps? Also, I need your guys opinion whether or not to paint this "Barn Fresh Beauty" Thanks!
  15. Y

    Correct Colors

    B-Maniac, That thing is gorgeous!!!! I wish I had more tractors so I could have a chance of one looking that good. I appreciate your help with the codes!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top