Search results

  1. M

    7410 FWA

    How good are the 7410 jd tractors. Looking at buying one with roughly 9500 hrs. Haven't physically looked at it, but do know the people that are selling it. Says everything works as should. Any idea on value? Up in North Dakota. Thanks
  2. M

    567 Baler

    Having trouble with the net wrap on my 567 baler, so was going to put twine in as a backup. The monitor will not switch to twine mode. Tried several times. Tractor running, tractor not running, just key on. Everything is hooked up correctly. Net wrap problem may be solved.
  3. M

    Tires for Belarus

    Any one know who manufactures front tires for my 825? They are a 13.6-20. Seems to be an odd size. Thanks
  4. M

    4010 Gas

    Changed out the gas sending unit on y 4010 gas. The old one had one wire connected to the center of it. The new one has the center connector stud, but also has another stud just coming off the flange. Should that one be grounded? No instructions with the new sending unit. Seems to be working...
  5. M

    400 versatile swather

    I am having trouble with my 400, to keep it running. Seems to have something to do with the heat. Runs for so long, then just dies. Can start it back up immediately, and it will idle just fine. Throttle up, and it dies. Sometimes if I sit for a minute or so, then it works again. Sometimes for 20...
  6. M

    825 Belarus

    Anyone have experience with these? Just purchased one at a farm auction. Seems like I am getting fuel into the crankcase.
  7. M

    825 Belarus

    Does anyone out there know anything about the Belarus tractor? I know they are very crudely built, but how are they for durability? Looking at a 825. Looks like it would make a nice loader tractor.
  8. M

    9030 bi-directional

    Any thoughts on these tractors? Seem to be very handy with the hydrostatic trany and 4 wheel drive. It is a 1992 model, if that makes a difference. Thanks in advanced.
  9. M

    4230 rear axle noise

    I have a clicking noise coming from the right rear axle when driving. Quad Range trany. Definitely is connected to speed of the tractor. Faster you go, faster the noise. Probably around 2 or 3 clicks per 1 revolution of axle. Just started out of the blue.
  10. M

    Skidsteer tires

    Blew a tire on my Bobcat. Can only afford to put 2 new ones on. Do I put them on the rear? The front? Or both new ones on the same side? Have heard all sorts of responses. I know I should replace all 4, but really cannot afford that at this time. Any advice would be greatly appreciated.
  11. M

    4010 gas

    Installed electronic ignition about 2 months ago. Replaced plugs at same time. Run like a dream. The other day ran fine, then spit and sputtered a bit and died. No fire coming out of coil. Replaced coil, same result. Have 12 volts on positive side of coil when key is turned on.
  12. M

    Electronic Ignition

    Is it worth the money to switch to Electronic Ignition in a 4010 JD?
  13. M

    4230 hydraulics

    I have a 1977 4230. it has 3 hydraulics, but only the 2nd one works on a single acting cylinder. Is there a way that 1 of the other 2 can be converted? I want to use this tractor on a Rowse double mower,
  14. M

    567 baler wrap

    May be the wrong time of year for this. but need to know. My 567 baler will wrap the bale, cut the wrap, but does not tell you to eject the bale. The buzzer goes off, and have to cancel it, then dump the bale. Doing it this way, it does not count the bales. Hard to check switches as I am usually...
  15. M

    Loader on 4230

    I have a loader on my 4230. It runs off my third hydraulic outlet. A couple days ago, it started to pop to neutral quite often. I made a wedge so it doesn't go to neutral, now it makes a noise, I pop it to neutral, turn it back on, everything is good for awhile. Hydraulics were checked last...
  16. M

    4050 Tractor PTO

    Just purchased a 4050 Tractor. The PTO runs when the tractor is running, unless under load. Having to stop the tractor every time to hook and unhook machines is a pain. Is there just an adjustment? Or is it something more intense?
  17. M

    1600 haybine

    Looking at a 1600 jd haybine. What are things to look for? What is the difference between the 1600 and 1600A? Thanks for the help
  18. M

    Re: Foot throttle pedal JD 4230

    Would like to know where to purchase a kit like this. Would love to have one on my 4230. Tractor with a loader definetely needs one.
  19. M

    Leon 790 Loader

    I have a Leon 790 for sale. People are asking if this will fit a FWA Tractor. John Deere mounts. Came off a 4430.
  20. M

    566 JD Baler

    What all is the difference between the 566 and the 567? Just some minor updates? Was the 566 as good a machine. Can't decide which one to buy. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top