(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. T

    Gravity wagon to running gear attachment

    Picked up a fairly new Unverferth 235 gravity box with 10 ton running gear. It had been bolted on all 4 corners but whoever did it drilled on an angle so the bolts came out close to the bottom. All 4 corners have the wood split near the bottom. About 1/2 of the wood split. There are also...
  2. T

    John Deere 4440 wire colors

    Trying to replace the front wire harness for a John Deere 4440. I have the service manual with the wire diagram as colors and numbers. I ordered a replacement harness from wiring harness.com. It was supposed to be the same colors. Nothing matches what I have on the tractor or manual. My...
  3. T

    Overcharging batteries 4440

    4440 voltage meter is in the orange high side. Checked and batteries reading 16.6 volts running. What causes this? Thanks
  4. T

    Removing muffler 4440

    Any advice for removing a stuck muffler on a 1982 4440? Removed the clamp and soaked with penetrating oil. No go.
  5. T

    Hardi sprayer connector

    Would like to replace this connector as it is broken. It is from a Hardi sprayer. Any idea what kind of connector this is?
  6. T

    Adding fertilizer to Kinze 3500

    Anyone add fertilizer to Kinze 3500? Looking at planters with inter plants and most don’t have the fertilizer option.
  7. T

    Striped corn field

    What makes a corn field look striped from the air? Noticed some look this way and some not.
  8. T

    Case backhoe bucket pin sizes

    Case 580 super K. Went to switch buckets from 24 to 12 for the first time yesterday and pins didn't fit the smaller bucket. Spacing was correct. Is this bucket for another 580 series or are different pins/bushings required.
  9. T

    Ferris ditch bank mower

    Going to look at a Ferris ditch bank boom flail mower. Any things to look out for or opinions on Ferris?
  10. T

    Troubleshooting John Deere100 monitor

    Have a 100 JohnDeere monitor for 7000 planter. Hooked it up and nothing. Previously worked good every year. I have power at the distribution panel but not sure where to go from there. Tim
  11. T

    4240 front pivot grease zerks

    Having trouble with getting grease into front pivot point zerks of a 4240. Had trouble before but jacking the front end up allowed grease to go in. Now I cannot get any in at either. Any suggestions? Thanks Tim
  12. T

    Trailer wiring

    Rewiring trailer and having issues. Installed new wire connector with junction box that made the wiring real clean and easy. Problem is only getting 8 volts at the junction box with the lights on. I get 12v with no load. If I run a ground wire from the junction box to truck I go back to 12v...
  13. T

    Removing wagon spindle

    John Deere 965 wagon gear. Any tricks to removing a stuck spindle? Removed top washer but only got it to move 1/4". Heating and beating doesn't seem to work Tim
  14. T

    Help me on knife inspection

    Have a 218 grain head for several years. Starting to cut sloppy and leave some. Looking at what to do for next year. The knife sections look worn, but how to tell if gaurds and wear plates are needed? Better to buy a new knife or replace all the blades? These are bolt in sections and...
  15. T

    Yazoo mower parts

    Anyone have any Yazoo mower parts? Looking for a couple wheel hubs part 0807-036, but would consider a complete transaxle. Nice old mowers bit parts are getting hard to find. Tim
  16. T

    4240 light question

    Have 4240 and 750 drill. The drill has lights which consist of 2 yellow and one red. When moving the yellows are suppose to flash and stopped the red is suppose to flash. It works about 50% of the time correctly. Going down the road the yellows will flash and the the red. What controls to...
  17. T

    Quick hitch with 3 point blade

    Have a 4240 with jd quick hitch and 8 ft blade. No problems last year at all moving snow. Last week pushing snow it popped out on one side. The levers were down. On inspection it appears that the gap between the tabs and quick hitch is about the same as the pins. Is this normal? Or is the...
  18. T

    John deere 6620 digital display

    The digital display on the 1979 6620 reads zeros for every function. Not sure what would cause all readings to stop working. Anyone have this happen in a 20 series? Tim
  19. T

    4240 engine oil pressure

    Went to move the 4240 today and noticed the engine oil pressure seemed low. Normally the pressure about pegged the meter until it got warmed up. Today it went up slowly and only got less then half way. It was out of the red, but wasn't like normal. Dad put almost all the hours (120) this...
  20. T

    Case 580k horn and flashers and RTD

    Recently acquired 1992 Case 580K. A couple of things don"t work trying to figure out. 1. The horn doesn"t work. Has power and the relay is kicking in (can hear it), but cannot find where the actual horn is. Anyone know where this is located? 2. Flashers and turn signals don"t work. The...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top