(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. D

    1020 John Deere Serial Number

    Hello, After doing some google searching I know this topic has been discussed in the past. Some of the information I collected is included below. After reading a few of the articles I was able to decipher most of the serial number but the part I am confused about is every where I look they...
  2. D

    Model 47 Loader Lift Cylinder Rebuild

    Hello, I am trying to rebuild the lift cylinder on a Model 47 loader. I got the rod/piston removed but am a little confused on how to remove the pistion from the rod. The nut is recessed into the piston. I could grab a pipe wrench but I am guessing that is not the recommended way to go about...
  3. D

    1020 Throw Out Bearing Replacement

    Hello, I have a 1020 with a Model 47 loader and sometimes when I let the clutch out I hear a knocking sound. To me it sounds like it is coming from under the gear shift levers. I am assuming it is the throw out bearing going bad. I tried to grease the bearing but have not been able to get...
  4. D

    1020 TSX 904 Carburetor Question

    Please reference the picture included. It is of the float bowl. The question I have is should there be a jet in the hole in the lower portion of the picture. There is two jets in the upper portion of the carburetor is this correct?
  5. D

    1020 with 47 Loader

    Hello, I have a 1020 with a 47 loader and the left hand lift cylinder is leaking from the rod end. I am assuming that it is the rod seal. Would this be a good assumption? Anyone got any tips on reair this? Or cylinder rebuilding?
  6. D

    1020 John Deere

    Hello, I am having a few issues with my 1020 John Deere. The first one is it starts with the ignition switch occasionally. Initially I thought it was the starter so I pulled it out and had it checked out and everything was good. Next I thought it was the ignition switch, but did a...
  7. D

    47 Loader Lift Cylinder Leak

    I have a John Deere 1020 with a John Deere 47 front end loader. One of the lift cylinder appears to be leaking out of the rod end of the cylinder barrel. Has anyine else have this happen before? Where would the oil be coming from? How difficult of a repair would it be to fix the issue...
  8. D

    Cub Cadet 102 Won't Start

    Hello, I have a Cub Cadet 102 that would shut off when it got hot. It would restart after it cooled down but would shut off again once it got hot. I checked for spark after it shut off and there was no spark. So I replaced the coil and condenser and now it won't start at all. Anyone see...
  9. D

    Re: Rock Shaft Housing Cover

    I ordered up a seal kit. Thanks for the reply
  10. D

    Rock Shaft Housing Cover

    Hello, I have a 1020 John Deere that the back of the rock shaft housing cover cracked on. Is this a common problem for this model of tractor? Anyone have any tips on replacing the cover? I checked with the local John Deere dealer and this part is no longer available. I did some searching...
  11. D

    Front End Loader for 1020

    Hello, I am trying to identify which model of loader is on the 1020 John Deere I have. I know it is a John Deere loader because I found a serial number plate but no model number. Which loader models fit on this model of tractor? Where would the model number be located? Thanks for your help.
  12. D

    Super M Top Tranmission Shqft Tolerance for Pilot Bearing

    Does anyone know what the tolerance is for the end of top transmission shaft where the pilot bearing rides for a Super M?
  13. D

    Super M PTO Engagement Lever

    Hello, I am working working on a Super M and had to remove the PTO shaft and rear housing. When reassembling I noticed that the rivet head on the PTO engagement lever is wore (see photo). I tried to get a replacement from the local IH dealer but they said it was no longer available. Does...
  14. D

    Oil Seals

    I am working on a Super M. I haven"t replaced any oil seals before and want to make sure I am doing it correctly. The first question I have is on the front of the lower transmission shaft and the PTO shaft. The seals I removed looked like it may have been a double seal and is approximately 1"...
  15. D

    Super M Torque Specs

    Hello, Does anyone know where you can find torque specs for reassembling a Super M? As of right now I have everything removed from the flywheel back. Thanks
  16. D

    Super M Transmission Gears

    Hello, Does anyone know where you can find new transmission gears for a Super M? Or if new gears are no longer available does anyone know where to get good used gears from? Thanks
  17. D

    Super M Lower Transmission Shaft Rear Bearing

    Hello, I removed the rear bearing from the lower transmission shaft and at the time did not realize that there was a "ridge" or raised portion on one side of the bearing. Would anyone be able to tell me which way the "ridge" or raised portion should be installed (front or back)?
  18. D

    Lower Transmission Shaft Coupler Nut

    Hello, I am trying to remove the lower transmission shaft and am having trouble remove the nut on the front of the lower transmission shaft. I have been told that it is a left hand thread. Is this true? Anyone have any suggestions on removing this? Thanks.
  19. D

    Transmission to Clutch Shaft Removal - Super M

    Hello, I am trying to remove the transmission shafts from a Super M. I posted a message earlier and now have a pretty good idea on how to remove the belly pump. After the belly pump is removed I was wonder how to remove the transmission shafts from the tractor. I have the differential out...
  20. D

    Super M Hydraulic Pump Removal

    Hello, I was wondering what steps I need to take in order to remove the hydraulic pump. Is it as simple as removing the bolt and lower the pump from the tractor? If not what other items to I need to remove or steps do I need to take? Thanks for the help!
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top