(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. R

    oil pressure

    I HAVE A 1941 FORD9N.tractor lost all oil pressure.checked oil filter canister which had no oil in it.drained oil and removed oil pan.inspected oil pump gears for wear and checked oil pump pickup tube for cracks.everything appears to look ok.i am at a lost.can anyone PLEASE give any...
  2. R

    oil pressure

    engine lost all oil pressure.drained oil and removed oil pan.removed oil pump from front main.removed plate and inspected pump gears.checked pickup tube for holes and cracks.everything seems to look good.in bottom of oil pan found this dial pin and clip.not sure where it is suppose to go.also...
  3. R

    SAVE IT OR SCRAP IT????

    i bought a 9n for 850.00 it has a scrap blade with it.the tractor would start but had popping and skipping until i replaced the points,condenser,and rotor button.cranked tractor yesterday popping and skipping gone.now i can hear knocking coming from oil pan.my question is should i keep her or...
  4. R

    wiring

    bought a 9n that has been changed from a 6 volt system to a 12v with a alternator.the original starter button has also been changed to a starter solenoid push button that hangs down under the dash.not sure if it's all hooked up right.any help would be appreciated.
  5. R

    fuel tank on 9n

    what is the best way to clean out light rust and trash out of the gas tank?
  6. R

    compression test

    i have a ford 9n.today i did a compression test cyl.1 is 80 cyl.2 is 65 cyl.3 is 80 cyl.4 is 70.when i give it gas it's skipping and popping.is this due to low compression readings.any suggestions?
  7. R

    firing order on motor

    wondering what the firing order is on ford9n
  8. R

    hood

    trying to remove hood to 1941 ford9n.so far i have removed all dash bolts and bolts at both sides of lower front fenders.still won't come of.
  9. R

    poppingskipping

    my 1941ford9n starts right up but when i give it gas it pops&skips through the exhaust.i checked cyl.#1and #2 both are not firing.tractor only running on #3and#4 cyl.changed spark plugs and still popping and no fire to #1and#2cyl.any suggestions on the next steps i should take?
  10. R

    compression??

    what should the compression be on a 1941 9n ford tractor?
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top