(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. S

    Need help to see what year my CAT's are.

    Hello everyone, these were my Grandfathers, he used to disk fields and vacant lots on the weekends as a side job back in the late 60's and 70's. I've never found any paperwork on them I just know the one is a CAT D4, and the other ??? I thought it was a CAT 22? I think it ran on gasoline if...
  2. S

    Ignition Coil TO30

    I ordered a 12 volt coil to replace my old one (12 volt also). But before I put it on I tested the new one with my multimeter on the ohms setting and the new one is reading 1.8? Now I'm not that familiar with all this but correct me if I'm wrong but isn't that telling me its really a 6 volt...
  3. S

    TO30 New Governor

    I got the new governor today that I ordered from this site. First it came with 2 shims? And the nut is threaded wrong, so I used the old one. I the new one supposed to be real tight in regards to the ball cage?? I mean the way it is they are real tight and don't really travel all the way...
  4. S

    Crankshaft Pulley

    I am replacing the governor on a TO30. What is the best way to remove the Crankshaft pulley bolt? And to keep it from spinning?
  5. S

    TO30 Battery Cables

    I have a TO30 that's been converted to 12 volt, I'm getting the 6 volt starter rebuilt to a 12 volt and I'm going to put all new battery cables. What size will be good? 2 gauge 1 gauge 0 gauge (1/0 GA)
  6. S

    TO30 Spark plugs

    Just curious on what brand and type spark plug do you prefer to run in your TO30 tractor? My starter just went out so I am dropping it off later to my local electric motor shop to get rebuilt. And so I figured in the mean time I'd catch up on some maintenance on it.
  7. S

    Ballast resistor

    I have a question that I get confused on, and that's whether or not to use the ballast resistor. I have a TO30 and it's been converted to 12 volt. I didn't go with an Alternator I instead had the generator rebuilt to a 12 volt at a shop they also provided me with a new voltage regulator. And...
  8. S

    1952 to30 no power

    Hello, I have a to30 that I got running again from sitting for bout 15 years. It's ran fine the last 2 years or so. Now it just struggles to pull a spring tooth through the field. It starts right up, and Idles good All the plugs are sparking so I was thinking maybe the carb is in need of a...
  9. S

    TO30 throttle not responding.

    Hello everyone, my TO30 has been running good, I just had used it a little last week. Today I went to use it and it started fine like always and when I went to the field with it and lowered the spring tooth it just barely goes at full throttle. Normally I can do the field at half throttle in...
  10. S

    Disc or Spring tooth

    I have a TO30 that I use a spring tooth for a couple of fields just for the weeds that come up. I was curious if this disc harrow would work also with my TO30 or is it to heavy? I don't want to over work my tractor.
  11. S

    Oil pan?

    I was wondering if anyone could tell me what to torque the bolts to on my oil pan for a TO30? And also I ordered a gasket and I was wondering what the two other little cut outs were for. I'm sure I'll see as soon as I drop the oil pan, but I was just curious. [/img]
  12. S

    Starter Question

    When we got our TO30 running again one of the problems was the Starter gave out, we used the one out of a TO35 we have. And I plan on taking the bad one from the TO30 to get rebuilt at the shop that did my generator, so I can put the other one back in the TO35. My question is the to30 is...
  13. S

    Gear Shift

    How do I replace the Boot that goes at the bottom of the gear shift on a TO30???
  14. S

    Disc Harrows

    I want to get a disc harrow for my 1952 TO30. I was wondering what to look for that is suitable for my TO30. Like as far as weight and all. Right now I have a spring tooth for it but that doesn't weigh much compared to a disc. I don't want to overwork or push my TO30 to much. I was looking...
  15. S

    Transmission, Hydraulic, Oil Change

    So my TO30 is now running good, but after my test run in the field I noticed the oil on the transmission dipstick is a thick light caramel looking color . So I read that they get water in there real easy from the boot on the shifter (and mine is cracked and falling apart). So I ordered a new...
  16. S

    Been fixing up my TO30

    First I'd like to say thanks to the advise Iv'e got from people on this forum, been very helpful. I finally got the rebuilt generator on and the now 12 volt system is working fine, also got the new radiator on, it's running pretty good for being so old. So now the last thing I did was change...
  17. S

    TO30 Radiator

    I'm waiting on a new radiator I just ordered for my to30 and I want to know is should I do something to flush out the engine block, like with a garden hose? I just was wondering since a new radiator and I know there is probably some crud in there that will in turn flow into the new radiator...
  18. S

    GAS?

    What's kind of gas is best for my TO-30? I've been having trouble keeping the tank clean ever since it was rusted up pretty bad. I cleaned it out with Muriatic Acid, and it looked like new, but it gets flakey real quick, so I heard that a Radiator Shop can clean them out so I'm going to try...
  19. S

    Oil Change on a TO30

    Out of curiosity always have put straight sae 30w motor oil in the tractor (engine) on my TO30. What's a close substitute to run in it if I couldn't get any 30w. Like would 20w50 or 10w40 work in it for the summer?
  20. S

    TO30 Electrical ?

    Hey guys I have a Ferguson TO30 past down from my Uncle and from what I can tell he had converted it to 12volt. The way it was set up as follows: A generator and a 4 wire regulator, a ballast resistor, and a 12 volt battery using a negative ground. And I assume the starter was still a 6 volt...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top