(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. R

    Freeze Plug Question

    Sean, I think you are correct. Took a quick look this afternoon and the plug appears to be tucked behind the coil, off to the side to the carb. I will need to get out the tool box this weekend and take a closer look. Yes, the darn thing is temperature sensitive despite much messing around...
  2. R

    Freeze Plug Question

    I would like to install a block heater in my 1972, Ford 2000, 3 cylinder, gas. Maybe I"m going blind but I can"t find the freeze plug. Does anyone know where it is located on this model? Thanks for your help.
  3. R

    Spontaneous PTO Problem

    Thanks to all of you who insisted that it was a clutch adjustment problem. That was the problem but with an unsuspected cause. After much head scratching, I discovered that the clevis on the clutch pedal end was hitting against a muffler clamp. This prevented the clutch from engaging a...
  4. R

    Spontaneous PTO Problem

    I recently sold my much beloved Jubilee and bought a 1972 2000, 3 cylinder, gas. The tractor was owned by a landscape contractor who had it stored inside for the past 5 years. It came with a number of known problems, most of which have been resolved by researching past posts on this board. ...
  5. R

    Electronic Ignition Install Problem

    Thanks for everyone"s input. The problem is solved. The tractor is a 2000, 3 cylinder gaser. Apparently a previous owner installed a dust cover that fit but was not from a 2000. The inside of the cover has a protrusion that extends down into the distributor and hits the magnet. The correct...
  6. R

    Electronic Ignition Install Problem

    It's Saturday morning and YT parts is closed. I have an installation problem with the electronic ignition kit I just purchased from them and perhaps someone can help me out. The magnet cannot be pushed down far enouch. It hits the small bolt that connects the upper breaker plate to the lower...
  7. R

    Oil Question

    Thanks to everyone for their expert response. Russ
  8. R

    Oil Question

    During the summer, I use 10W-40 oil in my NAA. The most readily available 10w40 oil is marketed as "heavy duty oil for diesel engines." Is diesel motor oil acceptable for use in my gasoline powered NAA? Thanks for the help. Russ
  9. R

    NAA Starter problem

    Thanks to everyone for your helpful advice. I began with the least expensive solutions and worked my way up to the more expensive. I don"t need to tell you the outcome - it was the most expensive fix that worked. It needed a new starter. Again, thanks for all your advice. Russ
  10. R

    NAA Starter problem

    I have a starter problem (I think) with my NAA. When attempting to start it, the solenoid clicks and squeals a bit but the starter does not crank. This is indicative of past corroded battery terminals. But a cleaning the terminals and even replacing the battery hasn't solved the problem...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top