gary in neb.
Member
so my load control shaft on my early 4020 was leaking. left control in "d", removed shaft put in new bushings, seals, as well as new bushings in main support. some moved load control to "l" and back to "d" while i was working on it, but did not see that it did anything to the arm in the rear end.
put it all together and now the 3 point only goes up about half way, no matter where i have the control, and it wont raise at all until the lever on the dash is almost all the way up. did it mess it up when the lever got moved (i think son was messing with it) or did someone try to adjust it with a bad shaft and now i have to readjust it? cant find my darn manual at this point so thought i"d try here.
thanks
Gary
put it all together and now the 3 point only goes up about half way, no matter where i have the control, and it wont raise at all until the lever on the dash is almost all the way up. did it mess it up when the lever got moved (i think son was messing with it) or did someone try to adjust it with a bad shaft and now i have to readjust it? cant find my darn manual at this point so thought i"d try here.
thanks
Gary