730 case

[wvcasedbman]

I installed a new hydralic control valve on my 730 comfort king when I was trying to reinstall the cast control lever on the splines it broke into 3 pieces! Looking for some help if anyone has one laying around they would part with. Good news is the 3 point arms go up again!

 

[Anonymous-0]

are you needin the small banjo shaped nooodler that actuates the valve shaft ,,?describing the one just inside that fastens to the stem behind the square plate ,,, if so , they are a commonpart ,, mine broke on my 730 ,, I was ableto match one up off of a clunker dc ,, not sure , perhaps a 70 series part will be the same

 

[wvcasedbman]

This lever is on the outside of the box and attaches to the splined shaft coming out of the box runs across the top of the box to the linkage for the three point lever

 

[Anonymous-0]

that lever is also common with manmy models ,,,however it mite be best to get the entire actuater stem that goes down in the pump behind the 4 screw plate ,,, I would not advise removing the lever from the stem ,,, got one on the 800 that I have to clamp vise grips on now you will be piddlin with it forever tryin to make the lever stay titely in place for parts thad at ruscha , can help ,, bob lee ,, elmers , john saelie , worleys near salem in

 

[wvcasedbman]

Thank you for your help