960 spin out rims

[grandpa Love]

I finally got around to busting the
nuts loose on spin out rims
yesterday. Lots of PB Blaster. On
right side all nuts were same size (
1 1/16) on left side 3 different
sizes and 2 studs are bent. Thinking
I need to swap em out. 2016 Steiner
catalog ain't got em. Any
suggestions? Thanks. By the way
that's the coolest thing that
tractor has done yet. Lol. My wife
says I looked like a big kid. Spun
em in and out at least 10 times!

 

[Dean]

CNH dealer (expensive) or (I believe) Dennis Carpenter.

Dean

 

[da.bees]

I needed to replace spin out wheels on a hundred series a couple of years ago and could only find later style wheels. To keep tractor origional I welded slots onto some new rims.
Those odd bolts and nuts fit the one odd clamp on each side that stops wheel from spinning past where you want it.

 

[Royse]

"Thinking I need to swap em out."

The rims, the nuts or the bolts?
The bolts can be replaced with carriage bolts.
Standard store stock would be course thread though and the nuts take a 15/16 socket.
Original were fine thread and the nuts took a 1 1/16 socket.
As tight as they need to be I like to stick with fine thread.

I have dozens of those original nuts around here.
Might have some of the bolts too.
Usually the problem is getting the originals out of the centers.
They get rusted in there pretty badly.

 

[agjim]

Tisco has the fine thread nuts with 1 1/16 hex, 33806s7, min order of 25 at about $1 each.
Flat washer- set of 6, 351505k6, six for $4.40 or 351505s8 by ones @$.90.