K-n-L Country Farms
Member
Me and my husband have been searching for an aftermarket kit or a way to design a better set up on both our 9n and 8n for the angle which is needed to press the brake and clutch... instead of being able to extend our leg out and press the brake and clutch at about a 45 degree angle, the operator has to press them nearly straight down.
We have tried search Red Rock Mfg as well as some other sites for over a year but no luck. So far it has been quite difficult figuring out a way to modify the clutch due to the mechanism where by the clutch's throw-out bearing shaft needs (facing the tractor sideways) rotated counter clockwise toward the front of the tractor to engage it and then can see how there are some other lever/cam mechanisms which are used to connect the clutch pedal to it.
The brake pedals are a bit easier to modify especially the brake pedal that controls the right side. The left side is a bit tricky though.
Would love some ideas, how-to's, and detailed pictures if anyone has modified the pedals to be pressed closer to a 45 degree angle instead of a 180 degree angle.
We have tried search Red Rock Mfg as well as some other sites for over a year but no luck. So far it has been quite difficult figuring out a way to modify the clutch due to the mechanism where by the clutch's throw-out bearing shaft needs (facing the tractor sideways) rotated counter clockwise toward the front of the tractor to engage it and then can see how there are some other lever/cam mechanisms which are used to connect the clutch pedal to it.
The brake pedals are a bit easier to modify especially the brake pedal that controls the right side. The left side is a bit tricky though.
Would love some ideas, how-to's, and detailed pictures if anyone has modified the pedals to be pressed closer to a 45 degree angle instead of a 180 degree angle.