FLAcharlie
Member
The U-joint zerk at the rear of the drive line where it connects to my Woods Brush Hog is really tough to get at. There is a quarter-sized hole in the drive line shield, but I have to at least partially remove the drive line shield to get decent access. It"s an angled zerk, but it seems near impossible to connect to it, as the U-joint is pretty much in the way. But I do manage to do it every year. This year I had to loosen the zerk and turn it some to get decent access, I haven"t had to resort to doing that previously.
The U-joint zerk on the front end of the drive line (closest to the tractor) is easy to get at.
Anybody have any suggestion for making this easier ?
How many operating hours is a grease job good for on the U-joint ?
The U-joint zerk on the front end of the drive line (closest to the tractor) is easy to get at.
Anybody have any suggestion for making this easier ?
How many operating hours is a grease job good for on the U-joint ?