Made up a 72 inch push blade for my skidloader. See these often at the factories for pushing snow off the dock with the forklift. My skid loader sits with the forks on it 90% of the time, if I need to move some snow or push up the burn pile I can stab this on quick and get it done. A buddy gave me the blade, and I had some 5 channel in the pile to make the frame. But two pieces of 5 inch x 2 inch tube 36 inches long for the fork pockets cost $86. And $10 in paint.
Square ring is for a short chain to the fork frame, though unless you have lots to do rarely needed, pressure of the forks will keep it on. But, in case I have to pull something back I added a ring on the front as well.
Square ring is for a short chain to the fork frame, though unless you have lots to do rarely needed, pressure of the forks will keep it on. But, in case I have to pull something back I added a ring on the front as well.