(quoted from post at 12:12:04 08/20/17) Have you ever had the pin out? There is supposed to be a single bushing in the center that is wide enough for the rocker to just fit on.
Do you have 2 bushings one on each side that slip into the rocker?
(quoted from post at 17:58:56 08/20/17)
This is an example of what too much enthusiasm can result in . :shock:
(quoted from post at 11:53:58 08/21/17) Hi
No I have not yet attempted to knock it out
and to be honest I'm not sure I want to
after seeing what can go wrong.
If it functions the way it is then maybe I
should just leave it.
If I do then I will cut through either side
of the flange so that I'm only having to
knock back a small sections at a time.
Is the original pin and bushings still
available.
(quoted from post at 12:10:45 08/21/17) Hi Ron
Why is the pin hinged on the middle???
I'm sure I may be able to get a spare part
from the wrecking yards over here.
Thanks
(quoted from post at 01:07:44 09/03/17) Hi Ron
Finally managed to cut drill and bash that
pin out no idea where or what it was. No
bushings found. So will purchase correct
hinge pin and a new rocket as this one is
broke. Where do I get the bushes from would
Sparex have them.
Cheers
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy