VFMerc
Member
I recently had my H go through major service. During the service the sediment bowl was replaced. I found the packing/washer associated with the handle damaged but my question concerns how this handle operates. When I open the valve handle, both nuts turn with the rotation of the handle. If the entire lever assembly moves away from its seat, what is the purpose of the outermost nut?
Also, when I was defueling the remaining fuel in the tank, with the valve in the "closed" position fuel continued to drain from the tank as soon as the bale on the sediment was loosened. I defueled the tank completely with sediment bowl in place but loose. This leads me to believe the handle in the closed position was not completely seated.
Is the assembly defective if the nut closest to the sediment bowl turns with the handle and does not hold its position and the packing/gasket against the sediment bowl assembly when the handle / valve is opened?
Also, when I was defueling the remaining fuel in the tank, with the valve in the "closed" position fuel continued to drain from the tank as soon as the bale on the sediment was loosened. I defueled the tank completely with sediment bowl in place but loose. This leads me to believe the handle in the closed position was not completely seated.
Is the assembly defective if the nut closest to the sediment bowl turns with the handle and does not hold its position and the packing/gasket against the sediment bowl assembly when the handle / valve is opened?